DETRUM GAVIN-6C User Manual page 14

GAVIN-6C Instruction Manual
When connecting the servo to the channel connector, please note the line
sequence. Each connector has 3 pins, one of the pins near the front panel is the
signal end, and the remaining two pins are the positive and negative.
 If the connectors become detached while flying, there will be a risk of
uncontrolled operation. Please securely insert all of the connectors as far as
they will go.
 The two antennas of the receiver should be placed at 90 degrees to each
other. Do not place the two antennas twisted together or in parallel.
Aileron channel
Elevator channel
Throttle channel
Rudder channel
Gear channel
Auxiliary channel
Auxiliary channel
Bind plug
(This is used during the bind procedure)
- 12 -
AILE
ELEV
THRO
RUDD
GEAR
AUX1
AUX2
BIND