NOCO Genius 7211368 Installation And User Manual
NOCO Genius 7211368 Installation And User Manual

NOCO Genius 7211368 Installation And User Manual

Carbon monoxide room alarm

Advertisement

Quick Links

Carbon Monoxide Room Alarm
Installation and User Guide Part No:
7211368
IMPORTANT: This Room Alarm should be wirelessly interlinked (paired)
to the Control Unit where there is a boiler, but no other fuel burning
appliance. Pairing must be completed before installing the alarm -
please see page 6.
GN2210/R2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 7211368 and is the answer not in the manual?

Questions and answers

Summary of Contents for NOCO Genius 7211368

  • Page 1 GN2210/R2 Carbon Monoxide Room Alarm Installation and User Guide Part No: 7211368 IMPORTANT: This Room Alarm should be wirelessly interlinked (paired) to the Control Unit where there is a boiler, but no other fuel burning appliance. Pairing must be completed before installing the alarm -...
  • Page 2: Table Of Contents

    CONTENTS INTRODUCTION FEATURES INSTALLATION INTERLINKING (“PAIRING”) THE CARBON MONOXIDE ALARMS TO THE NoCO CONTROL UNIT TO TEST THE NoCO ALARMS ARE CORRECTLY ‘PAIRED’ AND HAVE CREATED A NETWORK POSITIONING NoCO ROOM ALARMS FITTING THE NoCO ROOM ALARM TO TEST THAT THE NoCO ALARMS WILL SWITCH OFF THE BOILER IN THE PRESENCE OF A CARBON MONOXIDE LEAK REMOVING YOUR NoCO ALARM FROM ITS BASEPLATE WHAT WILL HAPPEN IN THE EVENT OF A CARBON MONOXIDE LEAK...
  • Page 3 USER LOCK OUT WHAT TO DO IN THE EVENT OF AN ALARM USEFUL CONTACT NUMBERS UNDERSTANDING THE PRODUCT INDICATORS (LEDS) MAINTENANCE TROUBLESHOOTING LOW BATTERY ‘CHIRP’ SILENCE DISPOSAL WARRANTY AND SERVICE CARBON MONOXIDE AND HOW IT CAN AFFECT YOU...
  • Page 4: Introduction

    INTRODUCTION Please keep this user guide in a safe place. If you move house, please hand it to the next occupier. The NoCO Carbon Monoxide Protection System is designed for use with gas or oil fired domestic boilers. When installed and interlinked with a NoCO Control Unit, as part of the NoCO Carbon Monoxide Protection System, this wireless carbon monoxide alarm will provide additional safety and peace of mind for you and your family.
  • Page 5: Features

    FEATURES • Detects carbon monoxide providing the earliest possible warning of toxic carbon monoxide levels from boiler flues or faulty fuel burning appliances. • Detects carbon monoxide continuously. • When installed with a NoCO Control Unit, as part of the NoCO Carbon Monoxide Protection System, this device will shut off the boiler in the event of a carbon monoxide leak.
  • Page 6: Installation

    INSTALLATION IMPORTANT: This NoCO carbon monoxide alarm must be linked to a NoCO Control Unit to create a Carbon Monoxide Protection System. Note: NoCO Room alarms should only be wirelessly interlinked (paired) with the NoCO Control Unit where there is no other fuel burning appliance within the property, to avoid the risk of nuisance boiler shut off where the source of carbon monoxide is not the boiler.
  • Page 7: Noco Control Unit

    • All NoCO alarms which are not paired will act as a standalone alarm and will still sound if they detect CO, however, they will not switch off your boiler. • NoCO alarms can only be wirelessly interlinked with products from the NoCO Carbon Monoxide Protection System range.
  • Page 8 Using a biro, press the “Pair” button of the NoCO alarm once, (one short press). The red LED on the back of the alarm will flash and then illuminate for 5 seconds. Within this 5 seconds press the test button on the NoCO Control Unit. 1.
  • Page 9: To Test The Noco Alarms Are Correctly 'Paired' And Have Created A Network

    TO TEST THE NoCO ALARMS ARE CORRECTLY “PAIRED” AND HAVE CREATED A NETWORK Note: This test will confirm the pairing of the units into a network, but will not switch off the boiler. A: Testing the NoCO alarms: In order to be able to see the Control Unit indicators at the same time as pressing the test button on the NoCO alarms, it is likely you will need two people to perform this operation.
  • Page 10: Positioning Noco Room Alarms

    POSITIONING NoCO ROOM ALARMS Once the NoCO alarms have been tested with the NoCO Control Unit, the NoCO alarms can be installed into position. WARNING: This NoCO alarm will only indicate the presence of carbon monoxide gas at the sensor. Carbon monoxide gas may be present in other areas, and so additional Carbon Monoxide Room Alarms are recommended particularly if other fuel burning appliances are located in the home.
  • Page 11 • Locate the NoCO alarm in a room where the occupant(s) spend most time. • If the domestic premises is a bedsit (a single room serving as both sitting and bedroom) then the NoCO Room Alarm should be put as far from the cooking appliances as possible but near to where the person sleeps.
  • Page 12 Where not to put the NoCO Room Alarm The NoCO Room Alarm should not be installed: • In an enclosed space (for example in a cupboard or behind a curtain). • Where it can be obstructed (for example by furniture). •...
  • Page 13: Fitting The Noco Room Alarm

    FITTING THE NoCO ROOM ALARM Figure 2. 1. Position the baseplate on the wall, ensuring the arrow marked on the baseplate is pointing upwards. 2. Secure the baseplate to the wall using 2 pan head screws (not supplied) and fixings appropriate to the material to which the alarm is being attached.
  • Page 14: The Presence Of A Carbon Monoxide Leak

    TO TEST THAT THE NoCO ALARMS WILL SWITCH OFF THE BOILER IN THE PRESENCE OF A CARBON MONOXIDE LEAK In order to be able to see the Control Unit indicators at the same time as pressing the test button on the NoCO alarms, it is likely you will need two people to perform this operation. Press and hold the test button on the NoCO Control Unit for more than 2 seconds and the boiler power will switch off.
  • Page 15: What Will Happen In The Event Of Acarbon Monoxide Leak Being Detected

    1. Re-fit all NoCO alarms back on their baseplates. 2. Wait at least 5 minutes for the system to re-establish the network. Once the Control Unit has recognised the NoCO alarm is back on its baseplate, the Fault LED (yellow) will change from a rapid flash to one flash every 10 seconds.
  • Page 16 Concentration Symptoms 35 ppm Headache and dizziness within six to eight hours of constant exposure. 100 ppm Slight headache in two to three hours. 200 ppm Slight headache within two to three hours; loss of judgement. 400 ppm Frontal headache within one to two hours.
  • Page 17: User Lock Out

    When the carbon monoxide gas dissipates, the NoCO alarms will silence automatically. The Alarm LED (red) on the NoCO Control Unit will emit a short flash once every 10 seconds to advise that there has been a carbon monoxide leak. USER LOCK OUT When the boiler is switched off as a result of a carbon monoxide leak, a Gas Safe engineer will be required to reset the boiler in order to switch it back on.
  • Page 18: Useful Contact Numbers

    Please carefully review this user manual to ensure that you know what actions to take in the event of an alarm. What to do during an alarm • Keep calm and open the doors and windows to ventilate the property. •...
  • Page 19: Understanding The Product Indicators (Leds)

    UNDERSTANDING THE PRODUCT INDICATORS (LEDS) Unit Power Alarm Action Status Fault (Yellow) (Green) (Red) required Flashes once per Standby None minute Flashes Open windows and evacuate. rapidly with Alarm Contact your Gas Safe loud audible registered installer. alarm Fault Flashing See Troubleshooting.
  • Page 20 • Do not spray aerosols on or near your NoCO alarm. • Do not use any solvent based products near your NoCO alarm. IMPORTANT: If you are painting, wall papering, or carrying out any other activity that uses substances that emit strong fumes you will need to remove your NoCO alarm from its baseplate, and store it in a safe location, ideally in a plastic bag for protection.
  • Page 21: Troubleshooting

    TROUBLESHOOTING The carbon monoxide alarms do • The CO alarms may not be wirelessly interlinked to the NoCO Control Unit. not sound when the test button on Please contact your Gas Safe registered installer. the NoCO Control Unit is pressed •...
  • Page 22: Low Battery 'Chirp' Silence

    LOW BATTERY ‘CHIRP’ SILENCE If the Fault LED (yellow) is flashing every 60 seconds and at the same time as an audible ‘chirp’, the alarm has a low battery. This alarm must be replaced as soon as possible and certainly within 30 days. Contact your Gas Safe registered installer to arrange this. While you wait for your replacement, it is possible to silence the audible chirp to prevent it causing a nuisance during the night.
  • Page 23: Warranty And Service

    Baxi warrants to the original purchaser that its Carbon Monoxide Alarm Part Number 7211368 is free from any defects in materials and workmanship under normal residential use and service for a period of 2 (two) years from the date of purchase.
  • Page 24: Carbon Monoxide And How It Can Affect You

    fitness for a particular purpose is limited in duration to 2 (two) years. This warranty does not affect your statutory rights. Except for cases of death or personal injury, Baxi shall not be liable for any loss of use, damage, cost or charge relating to this product, for to any loss, damage or indirect or consequential cost incurred by you or any other user of this product.
  • Page 25 Should you suspect CO may be affecting you or your family, open the doors and windows of your property to ventilate, turn off your appliances and evacuate the premises. At this time the authorities should be contacted to locate the source of the carbon monoxide before re-entering the building.
  • Page 26 WARNING: Do not use this carbon monoxide NoCO alarm on an intermittent basis, or as a portable CO alarm for trying to trace one source of the spillage of combustion products from fuel-burning appliances or from chimneys. DO NOT: • IGNORE ANY WARNING FROM YOUR NoCO ALARM! •...
  • Page 27 EDUCATE YOURSELF AND YOUR FAMILY ON THE SOURCES AND SYMPTOMS OF CARBON MONOXIDE POISONING AND HOW TO USE YOUR NoCO CARBON MONOXIDE CO ALARM PROTECTION SYSTEM. Tel: 0844 241 2504 Visit www.no-co.co.uk Open Monday - Friday 8am - 6pm Saturdays & Bank Holidays 8:30am - 2pm We are closed on Christmas Day &...

Table of Contents