Owner’s Manual Important Safety Instructions Read these instructions. receptacles, and the point where they exit from the apparatus. Unplug mains cord during Keep these instructions. transportation. Heed all warnings. 11. Only use attachments and accessories specified by Follow all instructions. the manufacturer.
Nēo MiND, immediately disconnect it from the component. To completely disconnect this AC mains and take it to your MOON dealer for a apparatus from the AC mains, disconnect the complete check-up. power supply cord plug from the AC receptacle.
MiND Nēo Series Introduction MiND Streaming Module Features: Thank you for selecting the MOON Nēo MiND Streaming Network Music Player as a part of your music UPnP Renderer (Universal Plug & Play). system. This component has been designed to offer DLNA 1.5 Compatibility.
Owner’s Manual Unpacking The Nēo MiND should be removed from its box with care. The following accessories should be included inside the box with your Digital-to-Analog Converter: AC power cable ‘CRM-3’ remote control with two ‘CR-2032’ batteries ‘SimLink™ cable with 1/8” mini plug terminations on each end wifi antenna (2x) This owner’s manual Warranty and product registration information (USA and Canada only)
Nēo MiND is successful or the 30 192.0kHz 48 & 4X second time limit has been exceeded. When “MOON MiND…” appears in the Bluetooth device wifi Note: The protocol doesn't officially support hi- list of your smart device, simply select it; the “BT”...
Nēo MiND directly into a dedicated AC outlet and functions to adjust the volume level on 340i / 350P. avoid using an extension cord. * Please speak with your MOON Authorized Retailer about the benefits of high quality cables for your system.
If you are using your Nēo hear a very faint click sound confirming that everything MiND with an older MOON product such as a P-7, P-8 or is in order. The blue LED on the front panel will i-7, you will need to update the software of the older illuminate, indicating that the Nēo MiND is now...
The Nēo MiND Network Player uses the ‘CRM-3’ full-function remote control (figure 3). It operates on the Philips RC-5 communication protocol and can be used with other MOON components. The ‘CRM-3’ remote uses two CR-2032 batteries (included). To install them, simply slide the back plate off;...
Page 12
MiND Nēo Series Remote operation with multiple MOON components Figure 4: Remote Operation with SimLink™ In figure 4 we have a Nēo MiND connected to a Nēo 340i Integrated Amplifier via their respective SimLink™ ports (using a 1/8” mini-jack cable). When you launch the MiND App on your Apple smart device and select this system’s ZONE, the MiND and 340i will both turn on.
B. Computer based music files stored on a “Network Attached Storage” (NAS) device or a computer C. An iPad, iPhone, iPod Touch or Android hand held device D. A Digital-to-Analog Converter with SPDIF, AES/EBU or Toslink inputs (MOON Nēo 280D shown) Legend:...
Page 15
Once the above connections are made and your Nēo MiND is operational, you should be ready to stream music. Start up the MOON MiND Controller app, and wait until the app discovers your Nēo MiND on the network (may take up to 30 seconds).
Page 16
Select the “security type” your network is set up for. (10) Enter your passphrase. (11) Tap “Save” on the top right side, and then tap settings to go back. Now tap “Done” in the zone view. (12) Close down the MOON MiND Controller app.
Owner’s Manual MiND Firmware Update Procdure (Appendix B) The Nēo MiND can be updated directly from the network by following these steps: (1) If the app is running, double-click the home button, select the MiND application and shut it down. (2) Power down the Nēo MiND using the rocker switch located on the rear panel , but keep it connected to your network (wired).
MiND Nēo Series MiND Hardware Reset Procdure (Appendix C) (1) Take note of your network settings in your MiND App (refer to the MiND Setup Guide procedure), since a hardware reset will automatically reconfigure these settings back to their factory defaults. (2) Power down the Nēo MiND using the rocker switch located on the rear panel .
Need help?
Do you have a question about the mind neo series and is the answer not in the manual?
Questions and answers