Subscribe to Our Youtube Channel
Summary of Contents for tfpro M16
-
Page 1: Table Of Contents
M16 INSTRUCTION BOOK CONTENTS Introduction The microphone input The line input The LED level meter The insert facility The solo facility The mute switch The pan control The channel fader The mixer The main outputs The monitor outputs The power supply... -
Page 2: Introduction
The input gain control is calibrated to give an idea of dB gain. When the phantom power push-button is pressed, 48V phantom power is applied to the XLR input. When using capacitor microphones, plug the microphone into the M16 before switching on phantom power. -
Page 3: The Line Input
HIGH PASS FIL TER The low frequency response of the M16 is extremely wide, going down to 8Hz. In certain circumstances this may cause problems, so a 2nd order filter (12dB per octave) at 75Hz is provided on each channel. A warning... -
Page 4: The Insert Facility
M16 INSERT FACILITY When the channels are being used as a mixer, the individual channel output can be used as a 'SEND' output for an insert. A separate balanced 'RETURN' socket is on the rear panel of each channel, labeled 'INSERT'. -
Page 5: The Channel Fader
M16 will be seriously damaged. The supply provides stabilized power of +15volts, -15volts and +48volts. The length of the power supply cable to the M16 is 1.8 metres and should not be lengthened. -
Page 6: Technical Specifications
Weight, 5Kg. OPERATIONS To operate the M16….. Place the M16 in a position where it is not close to other equipment that radiates magnetic fields; this includes television monitors and mains transformers. The M16 input transformers are susceptible to magnetic interference and care should be taken in this respect. -
Page 7: Problems
Connect inputs and outputs and plug in mains cable NOTE: THERE IS NO POWER ON/OFF SWITCH. Switch on the M16 a minute or so before using it so that the amplifiers are running optimally. Crackles when moving controls are possible immediately after switch-on. -
Page 8: Power Selection
M16 POWER SELECTION The M16 is fitted with a mains voltage selector for change of input voltage. To gain access to the changeover switch, disconnect from the mains and remove the top of the power supply unit by undoing the 4 screws. -
Page 9: Declaration Of Conformity 10
The EC Harmonised standards that have been applied are; a) Electrical equipment (safety) Regulations 1994 (S.I. 1994/3260) b) Electromagnetic Compatibility Directive (89/336/EEC) incorporating (S.I. 1992/2372) Distribution by TFPRO, Torquay, UK. phone +44 1803 316599 +44 1803 328333 email sales@tfpro.com DESIGNED BY TED FLETCHER AND MANUFACTURED IN ENGLAND.
Need help?
Do you have a question about the M16 and is the answer not in the manual?
Questions and answers