Telephone Recording; Troubleshooting - Whistler WVR-165 User Manual

Telephone Recording

¢ˆ Connect an adaptor you purchased separately for telephone recording and the
cable as shown in the following figure. Press the REC/STOP button to record
telephone conversations.
Line-in
Jack on the wall
Telephone Line Adapter
Output
Audio Cable
Note ¢—
¢
¢" If you record telephone conversations in VOS ON mode, the voice may
stop temporarily. We recommend to record in VOS OFF mode.
¢" If several telephones are connected to a telephone line, the voice of the
opposite person may be recorded in low volume. We recommend to connect
a single telephone to a line.
¢"The telephones which does not meet the standard
! Caution
of modular jack of the digital telephone available in
the digital communication are not supported.
25
Telephone
External MIC Terminal
HQ SPLP VOS
1 A-B

Troubleshooting

¢ˆ When you encounter any problem, check the following items.
Symptom Cause
Check whether the battery runs out.
Nothing is displayed
Check whether the polarities are correct. Make sure that the polarities
on the LCD screen.
Check whether the HOLD
button is set to ON.
Cannot not record.
Check whether the memory is full.
Check whether the battery runs out.
Check whether the HOLD
button is set to ON.
Cannot playback. Check whether your recorder has the
sound recorded.
Check whether the battery runs out.
Cannot hear sound Check the volume is set to 0.
from the speaker.
Check the earphone is connected.
Check the volume is set to 0.
Cannot hear sound
Check whether the earphone is
through the earphone.
connected firmly and correctly.
Check whether the USB cable
"ERROR" is
displayed on the LCD
is removed during formatting
screen and all
with connected to a PC.
buttons does not
operate.
26
Action
Replace the battery with a new one.
are correct.
Set the HOLD button to OFF.
Delete unnecessary recorded sound.
(See page 15 to 17)
Replace the battery with a new one.
Set the HOLD button to OFF.
Verify the number of the sound
recorded.
Replace the battery with a new one.
Control the volume.
Disconnect the earphone.
Control the volume.
Connect the earphone
firmly and correctly.
Format your recorder.
(See page 17)