1. Manuals
  2. Brands
  3. NSF Manuals
  4. Oven
  5. CBO-750 HYBRID-R
  6. Instruction manual

NSF CBO-750 HYBRID-R Instruction Manual

Hide thumbs Also See for CBO-750 HYBRID-R:
1
2
3
4
5
6
7
8
9
Table of Contents

Advertisement

Quick Links

Download this manual
|
CBO-750 HYBRID-R OVEN
Instructions Manual
ELECTRICAL DIAGRAM IS LOCATED BEHIND FRONT PANEL
THIS OVEN MAY BE OPERATED OUTDOORS.
ELECTRICAL DIAGRAMS ARE LOCATED BEHIND FRONT PANEL.
KEEP THIS MANUAL FOR FUTURE USE.
Chicago Brick Oven, LLC. | 205 E. Butterfield Road, #448 | Elmhurst, IL 60126
Customer Assistance: 630.359.4793
© 2016 Chicago Brick Oven. All rights reserved.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CBO-750 HYBRID-R and is the answer not in the manual?

Questions and answers

Related Manuals for NSF CBO-750 HYBRID-R

Summary of Contents for NSF CBO-750 HYBRID-R

  • Page 1 CBO-750 HYBRID-R OVEN Instructions Manual ELECTRICAL DIAGRAM IS LOCATED BEHIND FRONT PANEL THIS OVEN MAY BE OPERATED OUTDOORS. ELECTRICAL DIAGRAMS ARE LOCATED BEHIND FRONT PANEL. KEEP THIS MANUAL FOR FUTURE USE. Chicago Brick Oven, LLC. | 205 E. Butterfield Road, #448 | Elmhurst, IL 60126 Customer Assistance: 630.359.4793...
  • Page 2 TO INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE CONSUMER. TO CONSUMER: RETAIN THESE INSTRUCTIONS FOR FUTURE USE. WARNING! 1. DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE LIQUIDS OR VAPORS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. 2. AN LP CYLINDER NOT CONNECTED FOR USE SHALL NOT BE STORED IN THE VICINITY OF THIS OR ANY APPLIANCE.

  • Page 3: Installation

    Installation I. General outdoors only and not to be used in a building, garage or any other enclosed area. It is not • Upon receipt of your oven, thoroughly inspect for intended to be installed in or on boats or any damage.
  • Page 4 Installation Continued IV. Information for Use with a Self- Locate and orient the LP cylinder to provide proper vapor withdrawal. Connect the regulator to the Contained LP-Gas Supply System LP cylinder. Hand tighten it. Do not use a wrench. DO NOT STORE A SPARE LP GAS CYLINDER UNDER OR Check for leaks using a soapy water solution.

  • Page 5: Electrical Connections

    Installation Continued VIII. Electrical Connections When installed, the oven must be electrically grounded in accordance with local codes or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code Part 1, CSA C22.1. Electrical Rating Volts Amps...

  • Page 6: Shutting Down Instructions

    Installation Continued 5. Place ambiance burner “ON/OFF” switch in “OFF” position. 6. Set main gas supply cock in “ON” position. 7. Turn main electrical supply “ON.” 8. Place main “ON/OFF” switch in “ON” position. 9. If burner does not light, repeat steps 1-8. VII.

  • Page 7: Operation

    Operation IX. CAUTION: In the event of power Note: Due to thermal expansion, small cracks may appear in the dome or hearth during the curing process. failure, do not attempt to operate oven This is normal and the quality of your oven will not be until power is resumed.

  • Page 8: Maintenance

    Maintenance X. CAUTION: Oven must be “OFF” and • For service and repairs, contact factory, factory representative or local service company. cool before any cleaning is done. • All maintenance and/or repair MUST be performed Disconnect the power supply to the appliance before by someone trained/qualified to work on gas/ cleaning and servicing the oven.
  • Page 9 chicagobrickoven.com Chicago Brick Oven, LLC. | 205 E. Butterfield Road, #448 | Elmhurst, IL 60126 Customer Assistance: 630.359.4793 © 2016 Chicago Brick Oven. All rights reserved.

Table of Contents