LORD G-Link-200 Quick Start Manual

LORD QUICK START GUIDE
®
G-Link -200
Ruggedized High-Speed Triaxial Accelerometer Node
The G- Link- 200 wireless accelerometer node features an on- board triaxial
accelerometer that allows high-resolution data acquisition at noise levels as low
as 25 or 80 µg√Hz. The G-Link-200 can output continuous waveform data, or one
of four derived channels, including Velocity (IPS
and Crest Factor, allowing long-term monitoring of key performance indicators
while maximizing battery life.
To acquire sensor data, the G- Link- 200 is used with a LORD Sensing data
gateway such as the WSDA-101 or WSDA-1500 Base. G-Link-200 sensor nodes
come with the following components.
Item Description
A G-Link-200
B ½ AA, 3.6 V Lithium Batteries
Table 1 - G-Link-200 Components List
Wireless Simplicity, Hardwired Reliability™
), Amplitude (G and G )
rms rms pk-pk
Quantity
1
3
The G-Link-200 LEDs indicate operational modes showing when the node
is booting up, idle and waiting for a command, sampling, resynchronizing,
or if there is an error.
Indicator Behavior
OFF
Rapid green flashing
on start-up
Device
1 (slow) green pulse per
status
second
indicator
1 green blink every 2 seconds
Blue LED during sampling
Red LED
Table 2 - Indicator Behaviors
Node Status
Node is OFF
Node is booting up
Node is idle and waiting for a
command
Node is sampling
Node is resynchronizing
Error or low battery