Summary of Contents for Atronic Ithaca Epic 950
- Page 1 Ticket Printer Ithaca Epic 950™ ® for use in Atronic gaming machines Rev. 1.1 March 2006...
- Page 2 ELEASE Ticket Printer Ithaca Epic 950™ ® for use in Atronic gaming machines Rev. 1.1 Rel. March 2006 © 2005 - 2006 Atronic International GmbH. All rights reserved March 2006...
- Page 3 Ithaca Epic 950™ printer. The Epic 950™ printer supported by Atronic Hi(!)bitity ® is supported by Atronic e-motion™ and Harmony™ software levels B1.2.1 and gaming machines using software versions B1.2.1 and higher. Do not use this printer higher. Atronic Cashline™machines do not support...
- Page 4 ECHNICAL Ithaca Epic 950 - Technical Data Dimensions: Height: 67.5 mm (2.66") Width: 118 mm (4.66") Depth: 286 mm (11.25") Weigth: 1.7 kg (3.8 lbs) Printer type: Fixed linear thermal head 2.44" Print speed: max. 125 mm/sec. (text mode, monochrome)
-
Page 5: Remove Loaded Tickets
PERATING Remove loaded tickets The Ithaca Epic 950 printer has two ways to remove unused tickets from the printer mechanism assembly. • Unload tickets by opening the Ticket Cover • Unload tickets using the Feed Button Unload tickets by opening the Ticket Cover Ticket Cover 1. -
Page 6: Ticket Loading Procedure
PERATING Ticket loading procedure 1. Make sure that there is power to the printer. 2. Remove any loaded tickets remaining from the old ticket stack (see previous page). 3. Remove the tear off band from the new paper stack and place the paper stack into the ticket box. The printable (blank) side has to face down. -
Page 7: Cleaning The Printer
PERATING Cleaning the printer Use a soft brush to clean paper dust from inside the printer and chassis area. The paper dust should also be removed from the sensor optics. Top-of-Form / Ticket Out Sensor Cover Open Switch Paper Low Sensor Ticket Taken Sensor Ticket Burst Sensor... -
Page 8: Troubleshooting
PERATING Troubleshooting Printer status LED / Bezel status The Ithaca Epic 950 printer features a LED indicator system that provides the condition of the printer by using solid or blinking LEDs to communicate the status of the printer. LED Panel The following table lists the different LED indications. -
Page 9: Electrical Connections
PPENDIX Appendix Electrical connections Power and communication are supplied through the serial communications PCB located at the rear of the printer. The interface connector is a 14 pin Molex Minifit Jr ® The following table lists the pin connections. Function MRESET Not connected +12 V DC... -
Page 10: Dip Switch Setting
PPENDIX DIP-Switch Setting March 2006...
Need help?
Do you have a question about the Ithaca Epic 950 and is the answer not in the manual?
Questions and answers