Advertisement
Quick Links
1. Product Introduction
UES series solar charge controller is a kind of intelligent, multi-functional solar charge and discharge
controller. These serial products adopt customized LCD display screen, which makes the operation on the interface rather
convenient. All the controlling parameters can be reset flexibly to satisfy your different needs.
This controller has the following features:
● Visual LCD graphic symbol
● Automatic identification system voltage level
● Automatic temperature compensation
● Adjustable charge-discharge control parameters
●Accumulated function of charge and discharge ampere hours
● Battery low voltage protection
● Overload & short circuit protection
2. Specification
Model
Max. charge current
Max. discharge current
Max. solar panel input voltage
Rated voltage
Stop charge voltage
Low voltage recovery
Low voltage protection
USB output voltage/current
Characteristic
Operation temperature
Dimension of controller
Package size
Weight
*Parameters may customized by customers.
UES Series Solar Charge Controller
User's Manual
UES-2410
10A
10A
No load loss:≤10mA; Temperature compensation:-3mV/cell/℃
● Brief key operation
● Intelligent PWM charge mode
● Multiple selection of battery
● Settable operating modes of loads
● Battery over temperature protection
● Battery reverses polarity protection
● With Dual USB 5V output
≤55V
12V/24V auto work
14.7V/29.4V
12.2V/24.4V
10.5V/21.0V
5V 2A
-20℃~60℃
152×80.2×30mm (L*W*H)
163×95×40mm (L*W*H)
200g
UES-2420
20A
20A
Advertisement
Summary of Contents for XCSOURCE UES-2410
- Page 1 ● Battery low voltage protection ● Battery reverses polarity protection ● Overload & short circuit protection ● With Dual USB 5V output 2. Specification Model UES-2410 UES-2420 Max. charge current Max. discharge current Max. solar panel input voltage ≤55V Rated voltage...
- Page 2 3. Installation Instructions As shown in the installation connection diagram, the battery, solar panel, load and controller should be connected by turns. Please connect the battery first, and then the solar panel or load. Pay attention that the positive (+) and negative (-) polarity are consistent with the controller.
- Page 3 5. Parameters Setting At the setting interface, keep pressing the button for 5 seconds, the figure flickers, it means the controller enters into the setting mode. At this time, long press button for 5 seconds you can press the button to adjust the parameters. After finish setting the parameters, shortly press the button and the controller will save the set parameters automatically.
- Page 4 When the battery voltage lower than 10.5V (×2/24V), the controller enter into the state of low voltage protection, the icon appears in the bottom of the LCD and the Low voltage alarm icon flickers. The load is disconnected in order to prevent it from over discharging. At this time, you need to charge the battery.