Advertisement
Hole Location Template and Drilling
Instructions
This Isolation Switch can be mounted to
following Dairyland pedestals
Model MTP-36
Model MTP-42
1. See photo of each pedestal in the
instructions to determine the cover face
on which the isolation switch is to be
mounted. Do not mount on any other
cover face.
2. Align the bottom edge of this template
with the botton edge of the cover and
center it horizontally between the right
and left cover edges.
3. Carefully center punch mark the two
holes. The 6.856" dimension is critical.
4. Drill through the pedestal cover wall
with a 9/16" (0.531") drill bit but no more
than necessary to prevent drilling into the
decoupler product inside of the pedestal.
Reconfirm spacing with drill template.
5. Mount the switch per instructions
provided.
Dairyland Electrical Industries • P.O. Box 187 Stoughton, WI 53589 • 608-877-9900 • www.dairyland.com • marketing@dairyland.com
3.0" above bottom edge
of pedestal cover.
Advertisement
