Page 1
CMR51, CMR53 DKR72, DVM43 DYH25 Full-Size Full-Size SpaceSaver SpaceSaver High Chair High Chair High Chair High Chair Booster Seat Booster Seat Youth Chair Youth Chair IMPORTANT! Please keep these instructions for future reference. Adult assembly and setup is required. No tools are needed.
Consumer Information WARNING: When used as a high chair: Prevent serious injury or death from falls or sliding out. • Always use the restraint system. • Never leave child unattended. • Use upright position only with a child who is able to sit up unassisted. •...
Page 3
Parts Tray Seat Back with Restraints Tray Insert Note: The tray insert is attached to the tray. Footrest Infant Insert with Baby Wipes Compartment Seat Bottom with Restraints Note: The seat bottom has three parts: high chair seat, youth chair seat and chair attachment base.
Assembly and Setup for Full-Size High Chair Assembly steps 1-5 are one-time or a permanent assembly. Steps 6 - 16 complete assembly/setup for use as a full-size high chair. Frame Frame PRESS PRESS PRESS • Press the latch on the frame and open the leg until it "snaps"...
Page 5
Assembly and Setup for Full-Size High Chair Assembly and Se Seat Back PRESS PRESS PRESS PRESS Front Base • Position the front base so that it curves away from you. • While pressing the buttons on the front base, lower the front end of the frame assembly into the front base until you hear a "click"...
Page 6
Assembly and Setup for Full-Size High Chair LIFT Crotch Belt PRESS SIDE VIEW • Fit the crotch belt up through the large • Press the seat back adjustment button and lift opening in the pad. the seat back into the fully upright position. Waist Belts Lowest Slots •...
Page 7
Assembly and Setup for Full-Size High Chair Shoulder Belts Lower Slots SIDE VIEW Smaller Baby • Fit the upper pad pocket over the seat back. • Fit the shoulder belts through the lower slots in the pad for a smaller baby. Hooks Hooks Shoulder Belts...
Page 8
Assembly and Setup for Full-Size High Chair Infant Insert Footrest • At an angle, fit the tabs on the footrest into • Fit the shoulder belts and the waist belts the sockets in the front of the seat. Lower the through the slots in the infant insert.
Page 9
4 products in 1! Full-Size High Chair SpaceSaver High Chair (See pages 4-8) (See pages 10-11) Booster Seat Youth Chair (See pages 12-15) (See page 15)
Page 10
SpaceSaver High Chair Setup PRESS PRESS PRESS PRESS Chair Attachment Footrest Base • Lift to remove the footrest. • Press the lower buttons on the sides of the seat bottom and remove the chair attachment base from the youth chair seat. PRESS PRESS PRESS...
Page 11
SpaceSaver High Chair Setup High Chair Seat Chair Attachment Base . Make sure • Buckle the attachment straps you hear a "click". Pull the free end of the attachment strap to tighten on the adult FRONT VIEW FRONT VIEW chair •...
Page 12
Booster Seat Setup Footrest SIDE VIEW • Lift to remove the footrest. • Remove the pad upper pocket from the seat back. Hooks Hooks • Unfasten the hooks on the front edge of the pad from the seat bottom. • Push the waist and shoulder belts back through the slots in the infant insert and the pad.
Page 13
Booster Seat Setup Crotch Belt LIFT FRONT VIEW • Push the crotch belt down through the large • Lift the large tabs on the seat back and opening in the pad. remove the seat back. PRESS PRESS PRESS PRESS • Press the upper buttons on the sides of the seat bottom and lift to remove high chair seat from the youth chair seat.
Booster Seat Setup Seat PRESS PRESS PRESS PRESS Chair Attachment Base FRONT VIEW FRONT VIEW • Fit the seat to the chair attachment base. Push to "snap" in place. • Press the lower buttons on the sides of the seat bottom and remove the chair attachment base from the youth chair seat.
Page 15
Booster Seat Setup Youth Chair Setup Footrest • Lift to remove the footrest. • Wrap the back attachment straps around the back of the adult chair • Buckle the attachment straps . Make sure you hear a "click." • Pull the free end of the attachment strap to tighten on the adult chair PRESS PRESS...
Securing Your Child TIGHTEN LOOSEN • To tighten the waist belts: Feed the anchored end of the belt up through the buckle to form a loop . Pull the free end of the belt Repeat this procedure to tighten the other belt.
Page 17
Tray Use Tray PRESS PRESS • Press the button on the front of the tray • Fit the tray onto the armrests. to move the tray forward, backward or to remove. Tray Insert • Place the tray insert onto the tray.
Seat Height Adjustment Wheel Locks PRESS PRESS • Lower the tab on each rear wheel to lock in place. • Press the latches on each side of the frame and lift or lower the seat to the desired height. Seat Recline Adjustment PRESS •...
Baby Wipes Compartment Baby wipes are not included and sold separately. • Open the door on the compartment. Footrest PUSH • Lift to remove the footrest. Baby Wipes Compartment • While pushing the spring loaded plate, insert a container of baby wipes (not included Clips and sold separately).
Page 20
Baby Wipes Compartment Storage PULL PULL BOTTOM VIEW BACK VIEW • Fit the baby wipes compartment into the back side of the footrest. Tray BACK VIEW Footrest • Turn the tray face down. Pull the latches out. • Fit the tray onto the high chair legs. •...
Page 21
Storage Chair Attachment Base Footrest • Fit the chair attachment base to the bottom of the seat. Push to "snap" in place. • At an angle, fit the tabs on the footrest into the sockets in the front of the seat. Lower the footrest in place.
Dishwasher Safe The tray, tray insert, seat back and seat bottom are dishwasher safe. Footrest • Lift to remove the footrest. PRESS PRESS PRESS PRESS IMPORTANT! Remove the restraint system, pad and infant insert from the seat bottom and the seat back before placing in dishwasher. •...
Dishwasher Safe • When replacing the restraint system, we recommend that you buckle it as you would when restraining your child. This will make BACK VIEW it easier to see where each belt should be replaced in the seat. • Assemble the seat back to the seat bottom. •...
Need help?
Do you have a question about the CMR51 and is the answer not in the manual?
Questions and answers