1. Product Specifications The EFIS321 is Ethernet fingerprint image scanner based on capacitive solid-state MBF200 sensor from Fujitsu. It is designed for easy integration into security and/or service systems. EFIS321 supports 10/100 Mbps Ethernet interface 2 access modes, TCP client and TCP server...
2. Hardware Installation 2.1 Connectors description The EFIS321 scanner has Ethernet cable Cat.5E. The cable is used for Ethernet connection and for power supply of device. It uses the special adapter in order to support the power supply over Ethernet cable.
The EFIS321scanner has a capability to change the IP address. The winconefis321.exe utility lets to modify the specific parameters. If the IP address of EFIS321 is forgotten, it’s possible to set the default IP address by button. The default IP address is 192.168.100.10 port 5000...
Page 6
In order to set default IP address, press the button via hole and keep of it for 2-3 seconds. The EFIS321 scanner must be connected to power line in this time. The IP address of device is on the label. The label is placed on the box cover.
Page 7
Input the default address and press button “Read”. When you get the device configuration, you can press button “Reboot”. The device will be rebooted and takes the network configuration from flash memory of device. Note: You must be sure, that the other network devices haven’t IP address 192.168.100.10 in your network. User’s Manual EFIS321 Page 7...
In passive mode the scanner works as TCP server and waits a connection from TCP client. If TCP client has the connection from EFIS321 the client application can get the fingerprint image and control other feature of device by SDK.