Specification; Important Safety Instructions - Azden IRR-30 User Manual

Index
Page Subject
2

Important Safety Instructions

3 Handling care for Ni-MH battery
4 Introduction
5 Feature
6 System configuration, Installation case beside Plasma Display Monitor
7 IRR-30 Receiver set up
8 IRR-15 Receiver set up
9 IRB-10c Transmitter
10 IRN-10 Transmitter
11 IRH-15c Handheld Microphone
12 IRD-10/20/60 External Sensor
13 Trouble shooting
13 Microphone suggestions, Regulation
14

Specification

Important Safety Instructions
1. Read these instructions for use.
2. Keep these instructions in a safe place.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
8. Do not install near any heat sources such as central heating radiators, electric heaters, stoves,
or other units that produce heat (e.g. amplifiers).
9.Only use attachments/accessories specified by the manufacturer.
10.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with
the unit. When a cart is used, use caution when moving the cart/unit combination to avoid injury
from tip-over.
11.Unplug during lightning storms or when unused for long periods of time.
12.Refer all servicing to qualified service personnel. Servicing is required if the unit has been
damaged in any way, such as mains cable or plug damage, liquid has been spilled, objects have
fallen inside, the unit has been exposed to rain or moisture, does not operate properly or has
been dropped.
2
Specification
IRR-15/IRR-30 Receiver
Sub-carrier Frequency 2.06MHz&2.56MHz IRR-15: 1CH IRR-30:2CH
Type Super Heterodyne-Crystal Controlled
Modulation FM
S/N Ratio More than 90dB
Reception Sensitivity More than 25dBμV
Audio Output Adjustment Mic:-20dB maxLine: 0dB max
Audio Output Impedance Mic:Less than 1.5kΩLine: Less than 1kΩ
Power Requirement 12V DC 350mA
Size 100(W) x 161(D) x 44(H)mm (IRR-15)
215(W) x 210(D) x 44(H)mm (IRR-30)
Weight 530g (IRR-15)
1.15kg(IRR-30)
IRH-15c
Sub-carrier Frequency 2.06MHz&2.56MHz Switchable
Modulation FM
Microphone Element Type Uni Directional Dynamic
Battery Type 2-"AA" Alkaline (1.5V x 2)
2-"AA" rechargable Ni-MH or Ni-Cd(1.2 x 2)
Battery Life >8hours w/alkaline batteries -low power mode
>5hours w/alkaline batteries -high power mode
Size 240 x 58mm
Weight 300g w/alkaline batteries
IRB-10c
Sub-carrier Frequency 2.06MHz&2.56MHz Switchable
Modulation FM
Microphone Element Type Electret Condenser
Frequency Response 50-10kHz ±3dB
Battery Type 2-"AA" Alkaline (1.5V x 2)
2-"AA" rechargable Ni-MH or Ni-Cd(1.2 x 2)
Battery Life >10hours w/alkaline batteries -low power mode
>8hours w/alkaline batteries -high power mode
Size 100(H) x 64(W) x 27(D)mm
Weight 140g w/alkalaine batteries
IRN-10
Sub-carrier frequencies 2.06MHz or 2.56MHz
Modulation FM
Microphone element type Uni-directional electret x 2
Frequency response 50-9kHz ±3dB
Ext Mic Input Jack 3.5mm
Battery type 2-"AA" Alkaline (1.5V x 2)
2-"AA" rechargeable Ni-MH or Ni-Cd(1.2 x 2)
Battery life >10hours w/alkaline batteries- low power mode
>8hours w/alkaline batteries- high power mode
Size 80(H)x70(W)x27(D)mm
Weight 120g- Transmitter w/alkaline batteries
62g Transmitter w/o alkaline batteries
IRD-10/30/IRD-60
Output F-Connector(IRD-30/60) / RCA-Connector(IRD-10)
Power Powered by reciever (24V 10mA)
Size 52(W)x27(H)x73(D)mm (IRD-10)
72.5(W)×27(H)×50(D)mm (IRD-30)
100×30mm (IRD-60)
Weight 210g Included 10m cable and bracket(IRD-10)
90g Included mounting bracket (IRD-30)
170g Include mounting bracket (IRD-60)
15