Table of Contents
Advertisement
4 Connectors on the L-gateway Unit
This section provides an overview of the connectors on the L-gateway unit.
1A
1B
1C
1D
1E
1F
2A
2B
3
4
4.1 Assembling the Power-over-Ethernet RJ-45 connector
This section provides instructions for connecting the Power-over-Ethernet cable to the L-gateway
enclosure. The port labeled "Ethernet 0 (PoE)" provides both the Ethernet data connection to the
unit as well as the 48V/DC (802.3af compliant) power connection.
1
2
3
4
Assemble the water tight RJ-45 connector plug and connect the RJ-45 connector plug to the
Ethernet cable.
The information contained in this document is subject to change. This document contains proprietary information, which is protected by copyright
laws. All rights are reserved. No part of this document may be photocopied, reproduced or translated to another language or program language
without prior written consent of RFI Engineering B.V..
LoRa Radio 0, N-connector female
Optional LoRa Radio 1, N-connector female
Optional LoRa Radio 2, N-Connector female
Optional GPS connector, N-connector female
Optional radio connector
Optional radio connector
RS485 console port
Ethernet 0, including 802.3af PoE
Green power LED (on = power on)
Ground (earth) connectors
RJ45 plug
Gasket seal
Plug holder
Seal assembly
QIG_L-gateway_v1.20
Page: 6(12)
Advertisement
Table of Contents
