Subaru FORESTER 2004 Service Manual page 332

GLASS/WINDOW/MIRROR
NOTE:
Do not tilt the sash bracket to inner panel during ad-
justment. Otherwise smooth regulator operation
cannot be achieved.
(1)
(2)
(1) Sash bracket
(2) Rear sash
(3) Adjust a line parallel
(4) Rear sash
(5) Inner panel
10) Make adjustment of front sash in the same
manner as that of rear sash.
NOTE:
Although front and rear sashes must, as a rule, be
adjusted in the same manner, in some door instal-
lation, the adjustment in a different manner may be
required. However, adjustment of one sash to the
maximum amount and the other to the minimum
amount is not permitted. Such adjustment may re-
sult in application of excessive load to regulator.
11) After adjustments, tighten the nuts.
12) After adjustment to glass, close the door. If
there is a gap between outer lip of gusset and glass
surface, adjust the gap with adjusting nut (A) in low-
er fitting part of the gusset to prevent generation of
wind noise.
13) During adjustments, loosen the other three
clamping screws.
14) After adjustment, tighten the bolts and nuts.
Front Door Glass
(3)
(4)
(5)
GW-00026
(A)
GW-00056
GW-20