Advertisement
WARNING
This tool is not designed to handle or use combustible/volatile substances such as gasoline
or kerosene, in, on, or near the tool. The use of such materials may cause extreme hazardous
conditions.
Do not leave the tool exposed to harsh weather elements. Temperatures below freezing may
damage components and void warranty.
This is not a toy. Ensure children do not have access to the equipment. Do not allow children
to play with or near the unit.
Keep hair, loose clothing, fingers and all parts of the body away from all moving parts.
The Revolution was designed for use on hard surfaces only such as grouted tile, stone, or
concrete as per the instructions and recommendations written in this manual. Any deviation
from its proper use or purpose and the consequential damage that may occur is the sole
responsibility of the end-user.
Repairs are only allowed by a qualified service center. Do not attempt to disassemble or
repair the unit if you are not qualified to do so.
Do not drop or throw the unit. Treatment of this type can cause damage to the components
and create hazardous condition
FAILURE TO COMPLY WITH THE ABOVE WARNING INSTRUCTIONS WILL VOID THE
WARRANTY.
PREPARATION
Remove furniture from cleaning area, and remove any large debris and fibers by vacuuming
or wiping the surface to be cleaned.
Protect any cabinets, painted surfaces, walls, carpets, and other delicate materials from
overspray by masking, using painter's tape, drop cloths, plastic, or spray shields.
Identify the type of surface you are going to clean to ensure that you are using the proper
chemicals, brushes and equipment and will not damage the floor.
After identifying the surface, apply the appropriate pre-spray to the floor. To avoid longer dry
time before sealing, use only 5 minute dwell time or less and do not over wet the surface.
OPERATION
(Pressure range of 700-1500 psi and temperature up to 200°F)
Connect the Revolution to the vacuum and solution hoses from the extractor.
Turn on the extractor to engage the vacuum.
Make sure the bottom of the Revolution is flush with the surface to be cleaned to ensure
proper suction.
Squeeze the trigger to release the solution and move the Revolution at a moderate rate
overlapping just enough to ensure complete coverage. Moving too fast may create a spiral
pattern in the grout or tile.
Advertisement
