Page 3
Handling 15. Disengage the drive unit for the attachments, 1. Do not let the combustion engine run in enc- switch off the engine and pull out the spark losed areas, as dangerous carbon monoxide boot plug and the ignition key: gas can build up.
Page 4
• 10. Lower the mower unit when you park the mo- Do not use the cable for purposes other than wer or put it into long-term storage. that for which it is designed. • Do not carry the charger by its cable and do 1.2 Safety information for the charger not use the cable to pull the plug out of the •...
2. Layout and items supplied should come into contact with your skin, rinse down the aff ected area of skin immediately with running water. Make sure in any event Figures 1-57 can be found in the separate booklet that your eyes and mouth do not come into “Product illustrations for the Original Operating contact with the fl...
• 2.2 Items supplied Original Operating Instructions • Please check that the article is complete as spe- Product illustrations for the Original Operating cifi ed in the scope of delivery. If parts are missing, Instructions please contact our service center or the nearest branch of the DIY store where you made your Tools: •...
4. Technical data 5. Before starting the equipment Note: Assembling the components The enclosed manual from Briggs & Stratton pro- Some parts of the mower come disassembled. vides detailed technical data on the engine! The work of assembly should be carried out by 2 people.
6. Operation Important. Explosive gas is generated during the charging process. This could collect under the co- ver if closed and lead to explosive ignition. When Note: you charge the battery, refer to the safety regulati- For detailed information on starting the engine, re- ons supplied by the battery manufacturer.
Page 9
Mower unit switch (Fig. 31) 6.1 Mowing Use the ON/OFF switch for the mower unit (Item Only use a sharp blade that is in good condition. 16) to start the mower unit. This will prevent the grass blades from fraying and the lawn from turning yellow.
5. Release the locking brake. Slowly actuate the 6.3 After mowing drive lever (forward). Adjust the cutting height 1. Always allow the engine to cool before you and driving speed to the grass you are going put the lawn mower in an enclosed area. to mow.
Page 11
7.1 Cleaning 7.2 Maintenance The lawn mower should be cleaned thoroughly Important: The enclosed engine manual from every time after it has been used. This particularly Briggs & Stratton provides maintenance informa- applies to its underside and the blade mount. tion and maintenance interval information on the It is easiest to remove dirt and grass immediately engine.
Page 12
Important: Risk of injury when working with a 7.2.4 Care and adjustment of the cable pulls damaged blade. Oil the cable pulls at regular intervals (after every 25 hours in operation) and check that they move 7.2.2 Adjusting the mower unit (Fig. 42-43) easily.
7.4 Preparing the mower for transport 1. Drain the petrol tank using a petrol extraction pump. 2. Always let the engine run until it has used up the remainder of petrol in the tank. 3. Empty the engine oil from the warm engine. 4.
Warranty provisions or the store where you made you purchase guarantees the repair of defects or replace- ment of the equipment in accordance with the overview below. Statutory guarantee claims are unaff ec- ted. Category Example Warranty Defect with regard to material or 24 months construction Wear parts*...
The guarantee provided in this Guarantee Certificate is given by Einhell Australia Pty Limited ACN 134 632 858 of 6/166 Wellington Street, Collingwood, Victoria (Telephone number 1300 922 271) (Einhell Express Guarantee). CERTIFICATE GUARANTEE Dear Customer, All of our products undergo strict quality checks. In the unlikely event that your device develops a fault, please contact our service department at the address shown on this guarantee certificate.
Need help?
Do you have a question about the GE-TM 102 B&S and is the answer not in the manual?
Questions and answers