Configuring The Terminal; Terminal Commands; Upload - American Megatrends AMIDebug Rx User Manual

American Megatrends, Inc.
AMIDebug™ Rx – User Manual
USB to UART Bridge Controller" driver.

Configuring the Terminal

Use the COM port number listed in Device Manager to configure the terminal program.
Recommended COM Settings: 115200 baud, 8 bit, no parity, 1 stop bit, hardware flow control.
Once the connection is established, hit the ENTER key to confirm the connection is active. If the
connection is active, the user will see the following prompt:
Invalid command! Enter help for a list of valid commands.

Terminal Commands

A summary of terminal commands is generated by typing help at the command prompt.
help
Command list:
Help – This help menu.
Upload – Upload a string file to the device.
Download – Download a session or string file from the device.
Display - Dump a session or string table to the console.
Erase – erase a session or string table from the device.
Info - Display information about device.
Enter "help <command>" for further information.

Upload

The upload command uses the XMODEM protocol to upload a custom string table to the device's local
memory. The uploaded file is in ASCII TXT format.
Copyright ©2017 American Megatrends Inc. ● Public Document
Page 17 of 36