Advertisement
Drive Stop Module
Information in this document is subject to change without notice and does not
represent a commitment on the part of Dynamic Controls. No part of this manual
may be reproduced or transmitted in any form, or by any means, electronic or
mechanical, including photocopying or recording, for any purpose without the
written permission of Dynamic Controls.
Copyright 1998 by Dynamic Controls. All rights reserved.
Dynamic and DX are trademarks of Dynamic Controls
DX-ACC2
INSTALLATION MANUAL
Part Number
Version 2.0
GBK59698
(European reference No. GBK9998)
March 2003
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Dynamic Controls DX-ACC2
- Page 1 Information in this document is subject to change without notice and does not represent a commitment on the part of Dynamic Controls. No part of this manual may be reproduced or transmitted in any form, or by any means, electronic or mechanical, including photocopying or recording, for any purpose without the written permission of Dynamic Controls.
- Page 3 Intended Use Statement The DX-ACC2 is an accessory of the DX System intended to prevent unauthorised driving of a powerchair. Installation The Drive Stop Module is to be installed in a system already comprising a DX Power Module, and DX Master Remote.
- Page 4 DX Drive Stop Module, March 2003 With the DX system turned off, the Drive Stop 64mm module can be connected to any of the other DX 42mm modules being used in the system. This will normally be either the DX Power Module or DX 21mm Master Remote, but can be any other module with 42mm...
- Page 5 DX Drive Stop Module, March 2003 direction or speed that is not intended. Programmers should consider this risk when programming settings other than default. Electromagnetic Compatibility (EMC) Dynamic Electronic Controllers have been tested on typical vehicles to confirm compliance with the following EMC standards: Emissions: CISPR22, class B Susceptibility:...
- Page 6 DX Drive Stop Module, March 2003 International Standards Dynamic Controls products built today allow our customers' vehicles to conform to national and international requirements. In particular to: ISO7176-9 - Climatic Tests for Electric Wheelchairs ISO7176-14 - Power and Control Systems for Electric Wheelchairs...
- Page 7 DX Drive Stop Module, March 2003 Miscellaneous This manual must be read in conjunction with the installation manuals for all other DX Modules to be used in your application. Heed all safety and misuse warnings and if in doubt ask for advice. For further information and assistance, including Sales and Servicing, contact Dynamic.
Need help?
Do you have a question about the DX-ACC2 and is the answer not in the manual?
Questions and answers