1. Manuals
  2. Brands
  3. Cooper safety Manuals
  4. Switch
  5. EC400
  6. Installation manual

Cooper safety EC400 Installation Manual

Hide thumbs
1
2
3
4
5
6
Table of Contents

Advertisement

Quick Links

Download this manual
Cooper Lighting & Safety Ltd
Wheatley Hall Road, Doncaster
South Yorkshire,United Kindom
Telephone :
+44 (0) 1302 321541
Fax:
+44 (0) 1302 303213
email:
info@cooper-ls.co.uk
EC400 Installation Manual
Contents
1
2
wiring
3
4
5
6
7
2
2
3
5
5
6
6

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EC400 and is the answer not in the manual?

Questions and answers

Summary of Contents for Cooper safety EC400

  • Page 1: Table Of Contents

    EC400 Installation Manual Contents Introduction Hardware switch setting wiring Configuration of EC400 via console IP configuration DHCP Server Settings via Web-interface Multicast configuration Technical Specification Network Diagnostics Power LED Status LED Link LED Activity LED CNIP LED Server LED Status Button Cooper Lighting &...

  • Page 2: Introduction

    2 HARDWARE INSTALLATION Fig2 EC400 Connect power 9-24 Volts supply to EC400 as shown in Fig2 , for safety, it is recommended to use the panel 24 volts supply as this supply is battery back up in case of mains failure. Connect the internet cable as shown in Fig2.

  • Page 4: Ip Configuration

    Press x to save the IP settings and reset the EC400 in order to let the new IP settings take effect. You should now be able to add this EC400 to your channel IP list in the configuration server member list. More detailed instructions can be found in next section.

  • Page 5: Server Settings Via Web-Interface

    5 MULTICAST CONFIGURATION To reduce the traffic of information if more than 5 EC400's are on the network, it is recommended to use multicast addressing mode. IP-multicast is a technique to send data efficiently to many recipients at the same time in one IP network. All devices get the same multicast address in one multicast group.

  • Page 6: Technical Specification

    Installation ....... .Dill Rail mounting or wall mounting 7 NETWORK DIAGNOSTICS The EC400 is equipped with LED's as shown in Fig2 , these can be used as diagnostic tool without the need of specialist equipment. 7.1 Power LED (Green) The EC400 power LED lights up green when power is supplied to terminal 16, 17 (Fig 2) 7.2 Status LED (Red)

Table of Contents