Connect The Machine; Connect To Existing Water Lines And To Drain System - VBM Lollo HX User Manual

3. Connect the machine

3.1. Connect to existing water lines and to drain system

Check that the connections to the waterworks and the water outlets are complying with the current law
provisions; make also sure that there are no obstructions affecting the water outflow.
• Remove the Drip tray cover
• Remove the Drip tray
• Screw the Stainless Steel Hose to the 3/8 BSPT charge, and connect the other side
of the pipe (3/8 BSPT) to your existing water line.
• Connect the Drainage hose to the relevant cup provided under the Drip tray
IMPORTANT: make sure the incoming pressure is not above 4 bar; if this happens, install a pressure
reducer.:
The right pressure to brew espresso is between 9 -9.5 bar: this is the bypass setting of motor-pump.
If the incoming water pressure is more than the bypass pressure, the brewed water flux will hit the
coffee grounds too violently, over-extracting it. Over-extraction will negatively influence the physical and
chemical coffee values.
7