SBS H2 Installation, Operation & Maintenance Instructions Manual page 15

Maintenance Tips
To maintain the unit, it is recommended to:
Test the detector once a month by pressing the 'TEST' button.
1.
2. Vacuum the alarm cover once a month to remove accumulated dust.
3. Never use detergents or solvents to clean the unit or sensor. Chemicals can permanently
damage or temporarily contaminate a sensor.
4. Avoid spraying air fresheners, hair spray, paint or other aerosols near a sensor.
5. Never paint the unit or sensor. Paint will seal the vents and interfere with proper sensor
operation.
WARNINGS
Do not disassemble unit or attempt to repair or modify any component of this instrument. This instrument contains
no user serviceable parts, and substitution of components may impair intrinsic safety, which may adversely affect
product performance and result in injury
The SBS-H2 Hydrogen Alarm System is not a standalone safety device and does not provide protection from hydrogen
explosions. The relay contacts are intended to be connected to a safety system, enabling audible alarms, system shutdown,
ventilation, or other measures to ensure monitoring of hydrogen gas occurs before concentrations reach dangerous levels.
The information in this sheet has been carefully reviewed and is believed to be accurate; however, no responsibility is
assumed for inaccuracies. Storage Battery Systems, LLC reserves the right to make changes without further notice to any
product, datasheet, technical data bulletin, or website.
Storage Battery Systems, LLC makes no warranty, representation of guarantee regarding the suitability of its product for any
particular purpose, nor does Storage Battery Systems, LLC assume any liability arising out of the application or use of any
product and specifically disclaims any and all liability, including without limitation consequential or incidental damages.
"Typical" parameters can and do vary in different applications. All operating parameters, including "Typical" must be validated
for each customer application by customer's technical experts.
Storage Battery Systems, LLC products are not designed, intended, or authorized for use in any application in which the failure
of the SBS product could create a situation where personal injury or death may occur.
Should buyer purchase or use SBS products for any such unintended or unauthorized application, Buyer shall indemnify and
hold Storage Battery Systems, LLC and its officers, employees, subsidiaries, affiliates, and distributors harmless against all
claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal
injury or death associated with such unintended or unauthorized use, even if claim alleges that Storage Battery Systems, LLC
was negligent regarding the design or manufacture of the part.
In the case of a defect in the sensor, Storage Battery Systems, LLC shall not be liable for any damages which may result,
including, but not limited to, loss of revenue, property, or life. In an event, Storage Battery Systems, LLC shall limit liability to
replacement of the defective unit. Storage Battery Systems, LLC does not convey any license under its patent rights nor the
rights of others.
SBS-H2 Users Manual, Rev. 07-17-TNEMH2 Page 15 July 2017