Advertisement
MOU TI G I STRUCTIO S
2.11
Pour approximately 0.5 litre Öhlins suspension
fluid in front fork leg.
⚠
arninge!
Fluid level must be approximately 50 mm above
top of cylinder tube assembly.
2.12
Use a hex key to open compression and
rebound bleed adjusters fully. Install top cap
directly to shaft extension (no main spring or
preload tube). Pull up outer tube and tighten it
to the top cap with your hand.
[Htx kty 3 mm]
2.13
Pull outer tube up and down 10-15 times to
pump out all air from the cartridge.
2.14
Remove top cap from front fork leg.
2.15
Make sure that shaft assembly and outer tube
are in their bottom positions.
Set suspension fluid level according to chapter
"Setup Data".
2.16
Install shaft extension tool on top of shaft
extension.
Install main spring with the marking up (A),
preload tube and guide ring (B) and spring
support (C) over shaft extension tool.
[01765-03 shaft txttnsion tool]
2.17
Pull up shaft assembly and grab spring support
with a wrench tool.
[ rtnch 19 mm]
13
16
17
C
B
A
5
15
Advertisement
