Pre-Install Preparation - Cisco Meraki MR72 Hardware Installation Manual

Power Up/ Solid
Boot Orange
Connecting Rainbow
Connected Solid White
Upgrading Flashing
White
The MR72 may be operated in "Run Dark" mode for additional security
and to reduce the visibility of the access point. In this mode, the LED
will not be illuminated. This mode may be enabled through Meraki
Dashboard.

3 Pre-Install Preparation

You should complete the following steps before going on-site to
perform an installation.
3.1 Configure Your Network in Dashboard
Meraki recommends that you add your MR72 to a network in
Dashboard before mounting it in the field. The following is a brief
overview only of the steps required to add an MR72 to your network.
For detailed instructions about creating, configuring and managing
Meraki wireless networks, refer to the Meraki Cloud Controller Manual
(cisco.meraki.com/support/#documentation).
1. Login to http://dashboard.meraki.com. If this is your first time,
create a new account.
Power is applied
Device in process of connecting to
the Meraki Dashboard
Fully operational
During boot or no WAN link