Advertisement
Table of Contents
Advertisement
Table of Contents
Summary of Contents for Mustek MBT-H120
- Page 1 Headset Quick Guide...
- Page 2 Model No.: MBT-H120 FCC ID: HWF-MBTH120 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
- Page 3 Identifying the Parts Volume Up / Pairing Button Power / Talking Button Volume Down Indicator LED Red : Power Off Blue : Power On Red+Blue : Pairing mode Earhook Earphone Microphone DC-IN jack BLUETOOTH HEADSET GETTING STARTED BLUETOOTH HEADSET GETTING STARTED...
-
Page 4: First Time Use
Charging the Battery First time use: Remove the AC Adapter from the DC IN jack of the headset and the Please charge the built-in Li-ion bat- wall outlet. tery for 24 hours before the initial use. Low battery: When the battery is low, the indicator LED will fl... - Page 5 Wearing the Headset Wearing the Headset You can wear the headset on either To wear on your right ear: ear with the reversible earhook. Reverse the earhook to change its direction, and then follow the steps To wear on your left ear: above to wear it on your right ear.
- Page 6 Powering the Headset On or Off To power your headset on: Press the Power button for approxi- mately 2 seconds until the indicator LED starts to fl ash blue. Then you can start to operate your headset. To power your headset off: Press the Power button for approxi- mately 2 seconds until the indicator LED starts to fl...
- Page 7 To pair with a Bluetooth phone, Select “MBT-H120” from the please follow the instruction below: searched devices list and confi rm it. Ensure the headset is ON and Enter the passkey “1234” and enters the standby mode with confi...
- Page 8 Pairing with a Bluetooth Phone-continue If you have entered the passkey without previously pairing with another phone, the phone will be the “default phone” for your headset. If you want to use another Bluetooth phone with your headset, please switch the headset off, then disconnect it from the previous phone.
-
Page 9: To Reject A Call
Call Functions the voice tag through your To answer or end a call: headset’s microphone. When receiving a call, you will hear a 4) After recognizing the correct ring tone through the headset’s ear- voice tag, the phone number will phone. - Page 10 Headset Indicator LED While plugging in the charger: Flash Blue LED Signal Available once rapidly (Standby Mode) Indicator LED Headset every 3 seconds Light Red Charging Flash Blue LED Connecting Light Out Full Charge twice rapidly every 3 seconds Flash Blue LED Connected While unplugging the charger: 3 times rapidly...
Need help?
Do you have a question about the MBT-H120 and is the answer not in the manual?
Questions and answers