Page 1: Table Of Contents
Introduction Gg03 overview Getting started 6-11 Wearing the Gg03 11-12 Using the Gg03 13-18 Using the Gg03 with multiple Bluetooth devices 19-23 Function / Button matrix 24-25 LED indicator chart 26-27 Audio indicator chart Additional information 29-34 http:/www.gg2002.com Declaration of conformity 35-36 4F,#9,Ally2,Lane 35.Ji-Hu Rd., NeiHu, Taipei City114,Taiwan, R.O.C.
Page 2: Introduction
One USB charging cable. device that supports Headset profile or Handsfree profile. This manual focuses on how to use the Gg03 with your Bluetooth enabled phone. When the Gg03 is connected to your phone, you can do: One user guide.
Page 3: Gg03 Overview
Gg03 Overview Gg03 Overview 1.Indicator LED There are 3 colors(blue/red/purple) to show the status of the Gg03. 2.Multifunction button To answer, end, reject a call and control advance functions by constituting with volume control button (please refer to the Function/Button matrix).
Page 4: Getting Started
Approaching with the cradle to charging the battery of your headset. more than 1 day. The talk time of Gg03 is about 8 hours, and the standby time is about 220 hours. The more you talk using the Gg03, the less standby time your battery has. The Gg03 require longer charging times when not used over extended periods of time.
Page 5 1. Make sure the earhook forms an angle of 90˚. 3. It takes 90-120 minutes to fully recharge the battery. 2. Put the Gg03 on to the cradle. 4. Press the buttons on the both side of your cradle to remove the Gg03 from your cradle.
Page 6 You could start the operation now. Pair the Gg03 with your phone by adding it to the list of paired devices in your phone. The Gg03 should be paired once with your phone before use. The two devices then recognize each other Note 1: when they connect.
Page 7: Wearing The Gg03
Note: If the Gg03 is not successfully paired within 2 minutes, it will automatically leave pairing mode. If there is no paired data in the paired devices list of the Gg03, it will power off otherwise get into standby mode.
Page 8: Using The Gg03
After you have paired the Gg03 with your phone, you can make and receive a call using the Gg03 as if the Bluetooth connection is down. long as the Gg03 and your phone are turned on and these two devices are within range of up to 10 4. After you hear a beep, voice dial as you normal would.
Page 9 Note: 1. Make sure your phone support Handsfree profile. If your phone rings first, wait until the Gg03 rings, then short press the MFB. Your phone takes time to 2. When the Gg03 rings, long press the MFB until you hear a long beep.
Page 10 Bluetooth connection between the Bluetooth headset and the phone, so if these two If the Gg03 is turned on or got within range after a call has been initiated, you can transfer the sound devices can get into sniff mode( please refer to the LED indicator chart) when not during a...
Page 11: Using The Gg03 With Multiple Bluetooth Devices
If you have paired the Gg03 with the third phone, you can not put the Gg03 enter pairing mode. The paired devices list of the Gg03 is full now, so if you want to paire the Gg03 with Pairing the second/third phone with the Gg03 another phone, you must reset the Gg03 to clean the paired devices list.
Page 12 You can see the purple indicator quickly flash twice then the blue indicator and the red The Gg03 takes time to set up the Bluetooth connection with the n'th phone. If you hear the indicator cross blink per second, the Gg03 go into pairing mode automatically after resetting. You ring tone from the Gg03, just short press MFB again to answer this call.
Page 13: Function / Button Matrix
2. Redial the last call through the current connected device by long pressing the Volume down Voice dial using the current connected phone when connected Voice dial through the first paired phone when not connected button on the Gg03. Cancel voice dialing short press 1 time Cancel last call redial...
Page 14: Led Indicator Chart
LED Indicator chart LED indicator chart Function Button Last call redial using the current connected phone when connected Headset State LED Indication long press for 3 seconds Last call redial using the first paired phone when not connected Power off Red indicator blinks twice Reject a call long press for 3 seconds...
Page 15: Audio Indicator Chart
Sniff mode: The sniff mode is for power conservation and short response time purpose. There been achieved is already a Bluetooth connection between the Gg03 and your phone when in sniff mode, so do Incoming call Mobile phone ring tone or Gg03 default ring tone depends on not spend time to set up a Bluetooth connection when need.
Page 16: Additional Information
Gg03. If you will not be using the Gg03 for a while, store it in a place that is dry, free from damp, dust Do not use the Gg03 while the plane is in the air, Turn OFF the Gg03 before boarding any aircraft.
Page 17: Additional Information
Standby time 220 hours Power supply Talk time 8 hours Do not wear the Gg03 when charging. Normal re-charge time 1.5 ~ 2 hours Power supply must be connected to designated power sources as marked on the product. Battery type...
Page 18 4 hours before using. When the rechargeable battery of the Gg03 is low, there will be one battery low tone and the red Emergency calls indicator quickly flash twice every 5 seconds to alert the user.
Page 19: Declaration Of Conformity
Declaration of conformity Declaration of conformity FCC statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. 1. This device must accept any interference received, including interference that may cause undesired operation. 2.
Page 20: Regulatory Information
Regulatory information responsible for compliance could void your authority to operate the equipment. FCC RF radiation exposure statement: This Transmitter must not be co-located or operating in conjunction with any other antenna or This manual is published by G.G. Telecom, without any warranty. The information contained in this transmitter.