Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Advanced ALS-ELUM-RGB-CNTRL-1
- Page 1 InstallatIon InstRUCtIons elum RGB Controller Model NuMber ALS-ELUM-RGB-CNTRL-1...
-
Page 2: Table Of Contents
Table of Contents Page 1.0 General Information ……………………..………….. 2.0 Connections..………………........… 3.0 Switches ………………..………..…….....…. 4.0 Indicators ……………………........5.0 DMX Operation …............6.0 RDM Operation…………........….…. 7.0 Manufacturers Note............. 8.0 Stand Alone Settings ..........9.0 Effects Chart.............. -
Page 3: General Information
1.0 General Information This controller is designed to receive DMX512 protocol and to drive a number of Advanced Lighting’s LED strips. They use 24VDC power and three 0.5 - 5V analog control signals to vary the intensity of the red, green, and blue LED’s. The controller’s DMX input is fully opto- isolated and is bi-directional thus allowing the implementation of ESTA’s RDM protocol. -
Page 4: Switches
3.0 Switches DIP switches 1-9 The first 9 DIP switches are used to select the DMX address or to select one of the stand-alone special effects. Each switch is assigned a value. By turning on different combinations of switches, any DMX address or effect number may be selected. The switches have values as shown on the effects chart. -
Page 5: Dmx Operation
5.0 DMX Operation The interface uses 5 DMX channels to control the outputs. The starting address is set on the DIP switches or via RDM protocol. The first channel controls the red output, the second chan- nel controls the green output, and the third channel controls the blue output. This is the normal method for DMX control. -
Page 6: Manufacturers Note
7.0 Manufacturers Note After initial programming, the interface will be programmed with a default serial number. This electronic serial number must be changed from the default to a unique number for the interface to function in an RDM environment. The interface will not operate until this has been done. It will power up with the red output on at full intensity. -
Page 7: Effects Chart
9.0 Effect Chart Effect Number Description DMX Channel DMX Level Range RDM Address static red static blue static green static magenta 11 - 21 static yellow 22 - 32 static cyan 33 - 43 static warm white 44 - 54 static cool white 55 - 65 static blue magenta... - Page 8 LIMITED WARRANTY Nexxus Lighting, Inc. warranties its products, excluding lamps, to be free from defects in material and/ or workmanship, under normal condition, use and service, for a period of two (2) years from the original invoice date (Five (5) Years for Red, Amber and Orange FlexLED and Border Light LED products and one (1) Year for Non-UL Listed Power Supplies).