Related Manuals for Tamjets F-16 EDF
Summary of Contents for Tamjets F-16 EDF
- Page 1 1:12 Scale F-16 EDF Specification: Length: 54” Wingspan: 42” Weight: 8 lbs to 8.75 lbs Radio: 5-6 channel Fan size: 90mm Lipo: 8-12s www.tamjets.com...
- Page 2 Table of Contents Follow all the steps as photos showing in CD Step 1: Reinforcement wing former ............... Page 2 Step 2: Glue in plywood block to support wing spars (It very important to do this task) ............... Page 4 Step 3: Laminate gear door hinges with 5-6oz fiberglass .........
- Page 3 Step 1 Reinforce Wing Former Hysol Carbon Doublers Carbon Doubler Installed...
- Page 4 Step 1 Ply Doubler Installed...
- Page 5 Step 2 Wing Brace Support Cut Out Scrap ¼” Ply Drill 8mm hole You will want a snug fit when you slide it onto the spar...
- Page 6 Step 2 Hysol to the inside wing root This will stiffen up the wing for High “G” loads...
- Page 7 Step 6 Front Inlet Installation Inlet Installed...
- Page 8 Step 6 Drill & Tap for Set Screw...
- Page 9 Step 6 Inlet Secured Use scrap ply for inlet retainer This will prevent the inlet from being pulled back under high acceleration...
- Page 10 Step 7 Elevator Stabs & Pushrod Installation Hysol End caps Clean Pushrods and End caps with alcohol Hysol one End cap on each pushrod and let dry Attach pushrod to stab & tape in a neutral position Attach pushrod end caps to servos in neutral position Mark and cut push rods to length Glue servo side end on pushrods...
- Page 11 Step 7 Drill hole in fuse to tighten aluminum horn...
- Page 12 Step 8 Install Ventral Fins Locate & cut slits for the fins Drill holes in fuse for fin screws...
- Page 13 Step 8...
- Page 14 Step 10 Exhaust Tube and Fan Install Make a paper template to size Place template over Mylar sheet and cut to size...
- Page 15 Step 10 Tape the seem inside and Roll Mylar and temporarily tape large end to fan Slide the exhaust plywood piece over the small end Tape each end of the tube for a snug fit Remove plywood piece from the small end and remove from it from the fan...
- Page 16 Step 10 Make a cut out for your motor wires on the Mylar Tube Center tube onto the fan Insert motor with tube into the fuse...
- Page 17 Step 10 Check that your motor and tube are aligned Install exhaust outlet cover with ply support...
- Page 18 Step 12 Install canopy & cockpit floor Trim cockpit floor so that it slides into the canopy base...
- Page 19 Step 14 C.G. and Control Throws C.G. is 4.25” back from wing leading edge at the wing root Set throws as described in the above photo...
Need help?
Do you have a question about the F-16 EDF and is the answer not in the manual?
Questions and answers