Advertisement
Routan
PROCEDURE STEPS:
NOTE: Using a test light, verify the keyed power outlet being used is ignition switched. Power must not be
present with the ignition in the OFF position.
1. Move the passenger seat to the full rearward position.
2. Disconnect the negative battery cable.
3. Remove the four fasteners (2) on both sides of the stor-
age bin.
4. Carefully disengage the two spring clips from the top
center of the bin and pull the lower bin towards the
rear of the vehicle.
5. Route the Wi-Fi power harness (1) under the carpet
from the passenger seat to the instrument panel stor-
age bin (2).
March 24, 2009
WiFi Router
MINIVAN
K6860631 Rev. 1
Advertisement
Table of Contents
Summary of Contents for Autonet K6860631
- Page 1 5. Route the Wi-Fi power harness (1) under the carpet from the passenger seat to the instrument panel stor- age bin (2). March 24, 2009 WiFi Router MINIVAN K6860631 Rev. 1...
- Page 2 11. Solder the supplied fused pigtail to Wi-Fi power har- ness power wire. 12. Place the strands of the power side wires overlapping each other inside of the splice clip (1 ) along with the red fuse holder wire(2). March 24, 2009 K6860631 Rev. 1...
- Page 3 16. Center the heat shrink tubing (2) over the solder joint and heat using a heat gun. Heat the joint until the tub- ing is tightly sealed and sealant (1) comes out of both ends of the tubing. March 15, 2009 K6860631 Rev. 1...
- Page 4 17. Position lower bin into place and connect the elec- trical connectors 18. Seat the storage bin and engage the spring clip retain- ers. 19. Install the four fasteners (4) on both sides of the stor- age bin. 20. Connect the negative battery cable. 21.
Need help?
Do you have a question about the K6860631 and is the answer not in the manual?
Questions and answers