Summary of Contents for Guest 501
- Page 1 MODEL 501 RADIO CONTROLLED REMOTE SPOTLIGHT INSTALLATION AND OPERATION INSTRUCTIONS IMPORTANT ! READ THESE INSTRUCTIONS BEFORE INSTALLING AND USING THIS PRODUCT KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE...
-
Page 2: Installation
CAUTION! THE MODEL 501 COMPLIES WITH PART 15 OF THE FEDERAL COMMUNICATIONS COMMISSION RULES. CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE GUEST COMPANY MAY VOID YOUR AUTHORITY TO OPERATE THE SPOTLIGHT! The GUEST 501 BEAMER™ remote control spotlight consists of: The Spotlight / Receiver The hand held wireless remote (R.F. - Page 3 structures. Avoid locations where lines, anchors, sails or other hazards might damage the light. NOTE: Mounting the light as far forward or as high as possible can help to reduce reflected glare from the deck when the light is in use. 2.
- Page 4 Installing Transmitter Battery Note: Battery is included, but not installed to help prevent loss of battery strength when new. (1) Remove any static charges from your body by touching a metal grounded object. (2) Remove Transmitter from console mounting bracket, by slightly bending the tab back to release the transmitter from the bracket.
- Page 5 NOTE: If you wish to change the security code for your light, skip to the section titled: Changing the Security Code – OPTIONAL Then return here for re-assembly instructions. (6) Make sure membrane and top cover is re- assembled correctly with buttons protruding fully.
- Page 6 NOTICE LL RADIO ONTROLLED EMOTE POTLIGHTS ARE FACTORY SET TO THE SAME SECURITY ’ CODE F YOU HAVE A PROBLEM WITH ANOTHER PERSON S SPOTLIGHT INTERACTING WITH YOUR SPOTLIGHT OR WISH TO CHANGE YOUR SECURITY CODE FOR ANY REASON FOLLOW THE PROCEDURE OUTLINED BELOW A.
- Page 7 a. The position of each of the eight switches may be changed by using a small stiff object such as the end of a paper clip, or the end of a mechanical pencil with the lead retracted NOTE: It does not matter which code is chosen provided that all switches in the system are set to the same code.
- Page 8 Wiring the System. CAUTION! POLARITY IS CRITICAL. REVERSE POLARITY WILL DAMAGE THE LIGHT, AND RECEIVER. NOTES: 1. All black wires must go to a common ground. 2. Polarity is important - red to power / black to ground Initialization of System 1.
-
Page 9: Operation
3. If pressing the power button does not turn the light on and off, try pressing the directional control buttons, to see if the light moves in the direction indicated. If there is no movement check to make sure the wiring to the spotlight is correct and measures approximately 12 volts DC. -
Page 10: Maintenance
Mounting the Transmitter for console control operation (1) Remove Transmitter from the plastic console-mounting bracket by slightly bending the tab back to release transmitter from bracket. (2) Place the transmitter in the desired location and orientation. Test systems by operating the spotlight in all directions to verify you do not have interference between the locations. -
Page 11: Troubleshooting
B-23131 Troubleshooting Under normal use, your Guest Beamer spotlight will provide you with many years of reliable service. If your unit should become damaged by a severe impact, we recommend that you Contact Guest Company. (See last page) for technical support and parts information. - Page 12 If the lower motor makes no sound when it is activated, replace the lower motor. 6. If your light has a problem that is not described above, contact the Guest Service Department for advice. Be sure to have available a detailed description of the problem, proof of purchase (if requesting warranty service), and your daytime telephone, fax number, or e-mail address.
- Page 13 LIMITED WARRANTY For one (1) year from the date of purchase, The Guest Co., Inc. will, at its discretion, repair or replace for the original consumer, free of charge, any part or parts found upon examination by Guest Co., Inc., 95 Research Parkway, Meriden, Connecticut to be defective in material or workmanship or both.