Advertisement
Quick Links
Blower for hot air gravity distribution kit - modern
style with adjustable pipes (AC01389)
AC01387
INSTALLATION INSTRUCTIONS
THE BLOWER IS AN OPTION TO THE HOT AIR GRAVITY DISTRIBUTION KIT -
MODERN STYLE WITH ADJUSTABLE PIPES (AC01389).
This manual is available for free download on the manufacturer's web site. It is a copyrighted
document. Re‐sale is strictly prohibited. The manufacturer may update this manual from time to
time and cannot be responsible for problems, injuries, or damages arising out of the use of
information contained in any manual obtained from unauthorized sources.
Printed in Canada
or AC01388
(240v)
(120v)
45823A
11-12-2015
Advertisement
Summary of Contents for SBI AC01387
- Page 1 Blower for hot air gravity distribution kit - modern style with adjustable pipes (AC01389) AC01387 or AC01388 (240v) (120v) INSTALLATION INSTRUCTIONS THE BLOWER IS AN OPTION TO THE HOT AIR GRAVITY DISTRIBUTION KIT - MODERN STYLE WITH ADJUSTABLE PIPES (AC01389).
- Page 2 This assembly contains the following parts:...
- Page 3 Tools required for the installation Robertson #2 screwdriver Phillips screwdriver Power-driver with 5/16" (8 mm) hex head Ratchet with 11/32" (9 mm) hex head...
- Page 4 BLOWER OPTION INSTALLATION A thermal switch must be installed for proper blower operation. To do so, follow these steps. WARNING: ENSURE THAT POWER BEFORE STARTING INSTALLATION. 1- Remove the 4 screws (Q) of the junction box’s localization cap (R). Save the screws. 2- From the rheostat, bring the cable (S) (14/2 AWG) from above and through the opening in the air distribution box.
- Page 5 4- Pass the rheostat cable (S) and that of the power supply (T) through the respective connectors (E) and plastic sleeves (F) of the junction box (C). 5- Skin the wires/cables (S) and (T). 6- Set blower (A) to the center of the air distribution box and secure it with the self- piercing screw (N) and the washer (O).
- Page 6 7- Route the wires (U) (with connector) and (V) (without connector) from the blower motor through the wire grommet of the thermal switch bracket (B). Connect the wire with connector (U) on one of the two poles of the thermal switch. For next steps, see the wiring diagram 8- With a wire connector (Marrette) (M1), join the white wire of cable (T) to the wire (V) of the blower motor.
- Page 7 Wiring diagram...
- Page 8 13- Set the junction box (C) on the thermal switch support (B) using 4 nuts (J). Then, secure the thermal switch support to the air distribution box with 4 screws (Q) from Step 1.