Installing Drawers - Craftsman 33511 Operator's Manual

Lever Style - Lift or lower (depending on the slide) the
release lever on both sides, (this allows the slides to ride
over the stops.) Pull out to remove.
iNSTALLING DRAWERS
Ball bearing slide - Pull slides and slide carrier out to fully
extended position (see illustration.) Hold the slide on the
cabinet while aligning it with the slide on drawer. Slightly
insert one side and repeat for the other side. Slowly push
drawer to its fully closed position to engage slide. Open
drawer and reclose to ensure proper operation.
REMOVING AND iNSTALLiNG SLIDES
To remove the slide from the unit, first remove the
drawer.
• After removing the drawers drill out the rivets, use a
5/32-in drill bit. The rivets will need to be replaced.
• To reinstall the slide, place the slide in the appropriate
position in the unit and pull toward the front of the unit.
Replace rivets to secure slide to the unit.
• For smooth operation, make sure the drawers are
matched with their original slides.
\
\
\
\
\\\\\\
\ Y
slide carrier
/
slide
kLj L
_ OCKING THE UNIT
Cabinets:
• For units with a lock, insert the locking bar into the slot
in the center of the base. Move the locking bar toward
the unit until the other end fits into the slot in the top next
to the lock. Lock with the key.
• To unlock, reverse the procedure.
• Remove key.