Advertisement
PAIRING CONTROLLERS TO DRONES
IMPORTANT: Pair only one drone to one controller at a
time to prevent interference between drones.
1
underside of drone
I
O
Turn ON (I) one drone.
Both lights on top of the drone will blink.
3
I
O
Move left joystick up.
5
pairing light
Wait until pairing light shuts o . The controller will
beep twice after pairing.
REPEAT FOR ADDITIONAL DRONE.
4
2
pairing light
O
I
Turn ON (I) one controller. The pairing light will blink.
NOTE: Pairing works best with distance of approximately
3 feet between the controller and the drone.
4
I
O
Move left joystick down.
6
I
O
Press AUTO TAKE OFF / LANDING button to hover.
TROUBLESHOOTING
1
Drone is not ying or is ying erratically:
• The drone may have been unpaired from its controller. Pair the drone to the
controller again.
• Turn OFF (
O/
) the drone and the controller for 30 seconds before pairing again.
• Point the controller towards the drone when ying and stay within 50 feet of the drone at all times.
• Check the drone thoroughly for any damage or missing parts.
• The drone may shutdown on its own if it detects a problem.
• To restart, turn OFF (
O/
) the drone and back ON (I).
Then, pair the controller and try again.
• If the drone seems unstable after a crash, recalibrate it.
1. Turn ON (I) one controller and one drone.
2. Pair the drone to the controller. Drone and controller lights will be solid.
3. Push and hold both joysticks on the controller to the bottom left.
4. The red and green drone lights will blink for several seconds.
5. The lights will remain solid when calibration is complete.
2
The propellers move, but the drone does not y:
• The propellers may be broken. Check for broken or missing propellers and replace as necessary.
• The propellers may be installed incorrectly. Make sure the propellers are in the proper location on the
drone and reinstall. Never push the propellers too far or too hard onto the drone to prevent binding.
3
The drone drifts when hovering:
• Try adjusting the trim if the drone is off balance.
adjust forward
adjust backward
4
The drone will not y after pairing:
• After you turn ON (I) the drone and place it on a flat surface, you only have a few seconds to pair.
Turn on the controller. Then, quickly press the joystick up, then down. Once the pairing light turns off, press
the AUTO TAKE OFF / LANDING button.
• Pairing works best with distance of approximately 3 feet between the controller and the drone.
5
The drone crashes unexpectedly:
• The drone may need to be recharged. Follow the charging directions and allow the drone to charge fully
before operating. Each full charge will lend approximately 6 minutes of play time.
• Confirm the propellers are properly attached to the drone in their respective locations.
6
One drone always beats the other during battles:
• Attach different weapons or rearrange weapons on the drone.
• Weapons are intended to fall off during battle crashes. Reattach any fallen weapons before the next
battle.
• Change the drone speed when you are comfortable maneuvering the drone.
I
calibration
O
I
adjust to the left
adjust to the right
O
9
Advertisement
