Advertisement
Advertisement
Table of Contents
Summary of Contents for Craig CS1203
- Page 1 WIRELESS WEATHER STATION WIRELESS WEATHER STATION Model CS1203...
-
Page 2: Fcc Information
FCC INFORMATION: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may cause undesired operation. USER INFORMATION: CAUTION: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. -
Page 3: Location Of Controls
LOCATION OF CONTROLS Main unit: 1.LCD Display 2.TIME (Set) button 3.ALARM (Set/Off) button 4.UP button 5.Down button 6.CHANNEL (Selection) button 7.SNZ (Snooze) button 8.Battery Compartment TIME ALARM UP DOWN CHANNEL SNZ... - Page 4 Portable Sensor: 1.Bell Clip 2.Battery Compartment 3. C/ºF (Celsius/Fahrenheit) selection button 4.TX (Transmit) button 5.Channel selection button C/ F TX 1.5V 1.5V BATTERY INSTALLATION AND CHANNEL SET UP Main unit: 1.Press the tabs on the battery door and lift it off. 2.Install two (2) x AAA size batteries (NOT included) into the battery compartment as shown on the figure below and the polarity markings inside battery compartment.
- Page 5 Portable Sensor: 1.Slide the Bell Clip to either Left or Right and lift it off as shown on Fig. 1 below. 2.Remove the screws on the battery door. 3.Remove the battery door. 4.Install two (2) x AAA size batteries (NOT included) into the battery compartment as the Fig. 2 below and the polarity markings inside battery compartment.
-
Page 6: Battery Precautions
BATTERY PRECAUTIONS Follow these precautions when using a battery in this device: 1.Use only the size and type of battery specified. 2.Be sure to follow the correct polarity when installing the battery as indicated in the battery compartment. A reversed battery may cause damage to the device. 3.Do not mix different types of batteries together (e.g. - Page 7 Portable Sensor: 1.Temperature 2.Humidity 3.Transmittance Channel 4.Transmitting OPERATION AND SETTINGS MAIN UNIT Unit of temperature: Press the DOWN button repeatedly to set the unit of temperature to Celsius (ºC) or Fahrenheit (ºF) as desire. Display format of hour: Press the UP button repeatedly to set the display format to 12 or 24 hour as desire. Time set: 1.Press and hold the TIME (set) button until the current year appears blinking on the screen.
-
Page 8: Troubleshooting Guide
3.The digits of Minute will blink. Press the UP or DOWN button to set the Minute. When finished, press the Alarm button to resume normal display. 4.Press the ALARM button to activate alarm, the alarm on icon will appear on the screen. To cancel, press the ALARM button again, the alarm on icon will disappear. -
Page 9: Limited Warranty
Cashier’s check or Money Order for $7.00(to cover shipping and handling costs) payable to Craig Electronics lnc. For consumers in Canada, please make sure that the cashier check or money order is redeemable through a U.S. bank. Ship your product freight pre-paid. Your unit will be repaired, replaced or if the unit can not be repaired or replaced, a refund will be forwarded to you within four weeks of reeks of receipt of your unit. - Page 10 Under no circumstance shall Craig be liable for any loss or consequential damage arising out of the use of this product. This warranty gives specific legal rights. However, you may have other rights which may vary from state to state. Some states do not allow limitations on implied warranties or exclusion of consequential damage.
Need help?
Do you have a question about the CS1203 and is the answer not in the manual?
Questions and answers