Toshiba MV9DL2 Service Manual page 14

Spring Position
2-14: FE HEAD (RECORDER ONLY) (Refer to Fig. 2-14)
Remove the screw 1.
1.
2. Remove the FE Head.
FE Head
• The FE Head is not installed on the Video Cassette Player.
• Screw Torque: 4 ± 0.5kgf•cm
2-15: AHC ASS'Y/CYLINDER UNIT ASS'Y
(Refer to Fig. 2-15)
Unlock the support 1 and remove the AHC Ass'y.
1.
2. Disconnect the following connector:
(CD2001).
Remove the 3 screws 2.
3.
4. Remove the Cylinder Unit Ass'y.
NOTE
When you install the Cylinder Unit Ass'y, tighten the
screws from (1) to (3) in order while pulling the Ass'y
toward the left front direction.
Cylinder Unit Ass'y
2
(2)
• Screw Torque: 3 ± 0.5kgf•cm
2-16: CAPSTAN DD UNIT (Refer to Fig. 2-16)
1. Remove the Capstan Belt.
Remove the 3 screws 1.
2.
3. Remove the Capstan DD Unit.
DISASSEMBLY INSTRUCTIONS
Fig. 2-13-B
1
Fig. 2-14
AHC Ass'y
1
2
(1)
2
(3)
Fig. 2-15
• Screw Torque: 5 ± 0.5kgf•cm
2-17: MIDDLE GEAR/MAIN CAM (Refer to Fig. 2-17-A)
Remove the Polyslider Washer 1, then remove the
1.
Middle Gear.
2. Remove the E-Ring, then remove the Main Cam, P5
Cam, Pinch Roller Cam and Joint Gear.
Main Cam
Pinch Roller Cam
NOTE
When you install the Pinch Roller Cam, P5 Cam and Main
Cam, align each marker. (Refer to Fig. 2-17-B)
Pinch Roller Cam
Check the hole of Main
Chassis can be seen.
B2-4
Capstan Belt
Capstan DD Unit
1
1
1
1
Middle Gear
E-Ring
Joint Gear
P5 Cam
P5 Cam
Main Cam
Marker
Fig. 2-16
Fig. 2-17-A
Fig. 2-17-B