Table Of Contents - Kenwood RXD-DV90 Service Manual

RXD-DV90
CONTENTS / ACCESSORIES / CAUTIONS
Contents
CONTENTS / ACCESSORIES / CAUTIONS............. 2
EXTERNAL VIEW .......................................................3
ADJUSTMENT ............................................................4
WIRING DIAGRAM .....................................................5
PC BOARD ................................................................ 6
Accessories
FM indoor antenna (1)
(T90-0881-08)
Remote control unit (1)
(A70-1533-08): DV90K....YX
(A70-1534-08):DV90E.....TE
(A70-1535-08): DV90M....MM2
System configurations
SYSTEM RECEIVER
XD-DV90 RXD-DV90
XD-DV90(M2) RXD-DV90(M2)
XD-DV80 RXD-DV90
XD-DV80(Y) RXD-DV90
XD-DV80(M2) RXD-DV90(M2)
Cautions
The marking of products using lasers
(Except for some areas)
LASER PRODUCT
The marking is located on the rear panel and says that
the component uses laser beams that have been clas-
sified as Class 1. It means that the unit is utilizing laser
beams that are of a weaker class. There is no danger of
hazardous radiation outside the unit.
2
Loop antenna (1)
(T90-0882-08)
Batteries (R6/AA) (2)
SPEAKER
LS-N90V
LS-N90V
LS-N70V
LS-N70V-H
LS-N70V
CLASS 1
SCHEMATIC DIAGRAM .......................................... 15
EXPLODED VIEW ....................................................29
PARTS LIST..............................................................31
SPECIFICATIONS ......................................Back cover
Video cord (1)
(E30-7235-08)
SPEAKER
CRS-N90V
CRS-N90V
CRS-N90V
CRS-N90V
CRS-N90V
Operation to reset
The microcomputer may fall into malfunction (impossibility to
operate, erroneous display, etc.) when the power cord is un-
plugged while power is ON or due to an external factor. In this
case, execute the following procedure to reset the microcom-
puter and return it to normal condition.
Set the POWE key to ON. Then press the VIDEO/
AUX key while holding the TUNING MODE key
down.
÷ Please note that resetting the microcomputer clears the
contents stored in and returns and to condition when it left
the factory.
*AC plug adaptor (1)
(E03-0115-05)
* Use to adapt the plug on the
power cord to the shape of
the wall outlet.
(Accessory only for regions
where use is necessary.)