Assembly Instructions - Woods 600000 Owner's Manual

NOTE: This log splitter was partially assembled at the factory. Refer to the drawings and parts list should it become
necessary to disassemble the unit for repair or replacement of parts. The drawings in this manual are for refer-
ence only. Some of the components on your log splitter may look slightly different.
STEP 1:
Remove all the components from the crate. Inspect each piece for shipping damage. If any part is damaged, contact
your dealer or delivering carrier.
STEP 2:
Install wheel spacer (5) on axle prior to attaching wheel. Attach the two wheels (2) to the tank assembly (3) wheel spin-
dles using 3/4 flat washers (9), 3/4 NF slotted nuts (8), 1/8 x 1-1/2 cotter pins (6) and hub caps (7). These items are in
the hardware package. Tighten the slotted nuts and make sure the wheels rotate freely.
ITEM
1
Tongue Assembly
2
Wheel
3
Tank Assembly
4
Beam Assembly
ITEM
2
Wheel
3
Tank Assembly
5
Spacer
6
1/8 x 1-1/2 Cotter Pin
7
Hub Cap
8
3/4 NF Slotted Nut
9
3/4 Flat Washer
Page 10
DESCRIPTION
DESCRIPTION
QTY
1
2
1
1
QTY
2
1
2
2
2
2
2