Connecting Avcr; Connecting Avcr And Cable Box - Philips 43PP9202 Directions For Use Manual

Connecting Accessory Devices to Your TV
P
resented here is a connection example
involving a VCR and cable box.
Refer to the VCR's directions-for-use manual
for further information on connections.
To make the connections in this example, you
will need:
• one, two-way signal splitter
• two coaxial cables (75 )
• one cable for a video connection (standard
RCA connector)
• two cables for audio connections (standard
RCA connectors) (only one cable is needed
for connection to a nonstereo VCR).
NOTE: The cables are not supplied with your
TV. You should be able to buy them at most
stores that sell electronics. Or you can call
our Customer Care Center at 1-800-531-0039.
BEGIN
1
Connect a cable TV signal to a two-
way signal splitter.
2
Connect one of the two-way signal
splitter outputs to the INPUT on the
cable box.
3
Connect the other two-way signal
splitter output to the ANTENNA IN
75 on the rear of the TV.
4
Connect from the cable box OUT-
PUT jack to the ANT IN jack on the
rear of the VCR.
5
Connect the VIDEO OUT jack on
the VCR to the INPUT-AV 1 VIDEO
jack on the rear of the TV.
6
Connect the AUDIO OUT R(ight)
and L(eft) jacks on the VCR to
INPUT-AV 1 AUDIO jacks on the rear
of the TV.
NOTE: If the VCR is a nonstereo unit,
connect only the left audio cable,
which usually has a white connector.
7
Press the AV button on the remote
control as many times as necessary
to select the AV1 source.
8
Turn the VCR on and push PLAY to
view a videotape.
C
ONNECTING A
3
Rear of VCR*
AV1
TV
SWAP
DN
SOUND
STATUS/
EXIT
VOL
1
4
7
TV/VCR
A/CH
7
SURF
REC •
SAP
AV
ITR/
RECORD
POSITION
VCR C
AND ABLE
5
6
L
Two-way
Signal
Splitter
1
POWER
To simplify making connections, the con-
nectors on audio and video cables are often
color coded. The jacks on your TV are like-
wise color coded to match the connectors.
ACC
VCR
ACTIVE
PIP CH CONTROL FREEZE
The coding is as follows:
UP
• Yellow for video (composite)
PICTURE
• Red for the right audio channel
MENU/
SELECT
• White for the left audio channel
NOTE: If your VCR is mono (non-
MUTE
stereo), you will connect only one audio
CH
cable. You must ensure that the TV is set
to MONO for the signal source to which
you've connected the VCR (INPUT-AV 1,
2 3
INPUT-AV2, or the side panel inputs
5 6
[AV3]). Otherwise, you will receive
8 9 sound from only one of the TV's speak-
ers. See page 34.
0
SURF
PIP ON/OFF
FORMAT SLEEP
DOLBY V PROG.LIST
HOME HOME PERSONAL
VIDEO MOVIES
PIP
8
B
OX
Rear of TV
L
4
Rear of Cable Box
2
Coaxial Cable Lead-in from
Cable TV Company
H H
ELPFUL INT