yacht beam 6M Product Support Manual page 6

Searchlight remote control system with joystick remote control panel
Table of Contents

Advertisement

Wiring of remote control panel
The remote control panel is shipped with a 6-foot (1.83-meter) long, 20 AWG cable. The cable will be attached to the
searchlight and should be connected to the corresponding contacts on the remote control panel based on the wire color.
Refer to Figure 3.
Remote Control Panel
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
10
10
11
11
12
12
Installing the searchlight
The searchlight can be mounted where desired, using 3/8" length stainless steel fasteners. Keep navigational aids,
antennas, etc., out of the beam path of the light. It is recommended to mount antennas 10 feet (3.05 meters) above
the light, at a minimum. Be sure the 4 nylon shoulder washers, supplied with the searchlight, have been inserted in
the searchlight base mounting holes to prevent a galvanic reaction between the mounting hardware and the base of
the searchlight. Also make sure that the mounting base gasket is securely in place before bolting down. Silicone grease
should be applied to the bottom of the gasket to help in waterproofing the unit.
When mounting, be sure that the unit is able to rotate 360° without hitting any obstructions. Refer to Figure 4 for mount-
ing details. Mount unit so that the ID label on the mounting base faces forward. This is the home position when light is
reset.
See instructions on controls. See Section 4 for bulb installation.
WARNING: Xenon-Arc lights emit electromagnet radiation, which may
interfere with some communication or navigation systems mounted on board.
The preferred location for communication and navigation equipment system antennas is at least 3 meters directly above
the light.
After the light is installed, all critical communication and navigation systems should be checked for proper operation with
the light turned ON and rotated in all directions
Source DC 24V ± 10% 8.5A
Control Cable
AWG 20 0.5sq - 15c
WARNING: The searchlight is not designed for
inverted mounting.
Vinyl Cabtyre Cable
600V - VCT - 5.5sq - 2c
+ white
-
black
red
1
2
white
black
3
4
brown
yellow
5
green
6
light green
7
pink
8
light blue
9
orange
10
gray
11
blue
12
Vinyl Cabtyre Cable
300V - VCTF - 0.5sq - 15c
Figure 3
XENON SEARCHLIGHT
PP-307
+
-
1
2
3
4
5
6
7
8
9
10
11
12
CH1
6

Advertisement

Table of Contents
loading

Table of Contents