Table of Contents
Advertisement
2.
Follow instructions for steam ironing up to step 3.
3.
Ensure that the Steam Control Button is in the OFF position.
4.
Hold the iron vertically as close as possible to the fabric you wish to steam. Do not touch the fabric with
the soleplate.
5.
Pull the fabric tight with your free hand.
6.
Press the Burst of Steam Button repeatedly with intervals of at-least 3 seconds across the creased area.
7.
After using for approx. 25 seconds, place the iron back onto the power base for re-charging.
8.
You can then reapply vertical steam.
Note: When using vertical or burst of steam function, always ensure that there is sufficient water in the
tank. Allow for at-least 3 second intervals before repeating the steam function.
SELF-CLEANING
The self-cleaning feature cleans the inside of the soleplate, removing impurities. We recommend that this
feature is used every 5-10 days. By pushing the self-cleaning button a strong steam will be injected from the
soleplate, thus the iron can be cleaned from the inside to avoid the vents of the soleplate becoming blocked.
Set the Steam Control Button to the "OFF" position (no steam)
1.
2.
Fill the water tank to the 2/3 mark.
Set the Temperature Control Dial to "MAX" and put the iron onto the power base, allowing the iron
3.
to heat/charge for 2 minutes.
4.
Remove the iron from the power base and press the Self-Cleaning Button. Steam and impurities will
be emitted from the soleplate.
5.
When the tank is empty, place the iron back on the power base and let the iron heat up again for 1-2
minutes to evaporate any remaining water in the tank.
CLEANING & MAINTENANCE
1.
After using, first unplug the unit and allow it to cool down before cleaning.
2.
Empty out the remaining water. Hold the soleplate away from you while doing this incase it is still hot.
WARNING:
The contents of the water tank may also still be hot.
3.
Wipe the soleplate with a soft wet cloth and keep it level and smooth avoiding metal-friction.
4.
Scrub incrustation off the spraying nozzle with a toothpick.
5.
Wash the inside of the water tank frequently. First fill with water, and then sway it from side to side
finally pouring out the water through the water opening.
6.
Don't use strong acid or alkali products on the iron as this may damage the frame and produce a colour
change to the body of the unit.
7.
Do not use harsh abrasive cleaners or solvents when cleaning the iron.
8.
Pour the water in the water tank out completely after using every time, then store it upright.
6
Advertisement
Table of Contents
