Pioneer SC-27 Service Manual page 15

5
RETURN – Press to confi rm and exit the current
menu screen (also use to return to the previous menu
with DVDs or to select closed captioning with DTV).
9 / / / (TUNE/PRESET) /ENTER
Use the arrow buttons when setting up your surround
sound system and the Audio or Video options. Also used
to control DVD menus/options and for deck 1 of a double
cassette deck player.
Use TUNE / to fi nd radio frequencies and use
PRESET PRESET / to fi nd preset stations.
10 Component control buttons
The main buttons ( , , etc.) are used to control a
component after you have selected it using the input
function buttons.
The controls above these buttons can be accessed after
you have selected the corresponding input function
button (for example DVD, DVR or TV). These buttons also
function as described below.
Press TUNER fi rst to access:
MPX – Switches between stereo and mono reception
of FM broadcasts. If the signal is weak, then switching
to mono will improve the sound quality. NOISE CUT
MODE 1 to 2 can be selected when receiving AM
broadcasts.
Set the remote control operation selector switch to
RECEIVER fi rst to access:
STATUS – Press to check selected receiver settings.
PHASE CTRL – Press to switch on/off Phase Control
or Full Band Phase Control.
CH LEVEL – Press repeatedly to select a channel,
then use / to adjust the level.
PQLS – Press to select PQLS setting.
AUTO/ALC/DIRECT – Switches between Auto
Surround, Auto level control, Optimum Surround mode
and Stream Direct mode.
STEREO – Switches between stereo playback and
Front Stage Surround Advance modes.
STANDARD – Press for Standard decoding and to
switch between the various
Neo:6 options.
ADV SURR – Use to switch between the various
surround modes.
THX – Press to select a Home THX listening mode.
11 Number buttons and other receiver/component
controls
Use the number buttons to directly select a radio
frequency or the tracks on a CD, DVD, etc.
ENTER can be used to enter commands for TV or DTV.
After set the remote control operation switch to
RECEIVER:
SIGNAL SEL – Use to select an input signal.
SLEEP – Use to put the receiver in sleep mode and
select the amount of time before sleep.
DIMMER – Dims or brightens the display.
5
6
Pro Logic IIx and
SC-27
6
7
A.ATT – Attenuates (lowers) the level of an analog
input signal to prevent distortion.
SBch – Use to select the surround/virtual back
channel mode.
MCACC – Press to switch between MCACC presets.
HDMI OUT – Switch the HDMI output terminal.
Press TUNER fi rst to access:
D.ACCESS – After pressing, you can access a radio
station directly using the number buttons.
CLASS – Switches between the seven banks (classes)
of radio station presets.
12 SOURCE
Press to turn on/off other components connected to the
receiver.
13 Remote control illumination button
Press to turn on/off the illumination of some of the
1
buttons and the LCD light.
14 Remote control operation selector switch
Set to RECEIVER to operate the receiver, TV or SOURCE
to operate the TV or the source device.
When this switch is set to RECEIVER, the receiver can be
controlled (used to select the white commands above the
number buttons (A.ATT, etc.)). Also use this switch to set
up surround sound.
15 VOL +/–
Use to set the listening volume.
16 MUTE
Mutes the sound or restores the sound if it has been
muted (adjusting the volume also restores the sound).
17 AUDIO – Changes the audio or channel on DVD or BD
discs.
DISP – Switches between named station presets and radio
frequencies.
CH +/– – Use to select channels for DVD/DVR units.
7
8
A
B
C
D
E
F
15
8