Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Installation Manual
Advertisement
Table of Contents
Related Manuals for Kraus KPF-1622
Summary of Contents for Kraus KPF-1622
- Page 1 I N S TA L L AT I O N MA N UA L Single Lever Pull-Out Kitchen Mixer KPF-1622 www.kraususa.com I toll free: 1.800.775.0703 I © 2014-2015 Kraus USA Inc. I REV. August 16, 2016...
-
Page 2: Tools Required
1 5/8” (42.5 mm Max) • Make sure you have all necessary parts by checking the diagram and parts list. If any part is missing or damaged, please contact Kraus Customer 7/8” (22mm) Service at 800-775-0703 for a replacement 19.7 º... - Page 3 KPF-1622 Diagram and Parts List Diagram and Parts List Included Parts: 1. Faucet Body 2. Aerator Head Aerator 3. Base 4. Base O-Ring Pull Out Ho 5. Rubber Washer 6. Mounting Nut 7. Mounting Screws 8. Weight 9. Hot & Cold Waterlines 10.
- Page 4 Faucet Dimensions 7” (179 mm)
- Page 5 Faucet Dimensions Step Step...
-
Page 6: Installation Method
Faucet Installation Methods Installation Method 1 The minimum distance between the faucet hole and wall should be 3.5” Installation Method 2 Step 1 If the distance between the faucet hole and the wall is less than 3.5”, position the faucet lever 30 degrees to 90 degrees off the wall to allow for full operation... - Page 7 Installation Steps Step 5 Step 1 Step 1 Remove mounting hardware assembly (E) Hexagon Nut Cold Water Water Step 2 Step 6 Connect waterlines (G) to hot and t the faucet bo 1. Remove mounting screws (9), mounting nut (8), metal was cold copper lines on faucet (4) and base o-ring and rubber washer (6) from the faucet body (1).
- Page 8 Step 3 Insert faucet body (A) into hole on deck or sink with base (C) and base o-ring (D) attached. Attach mounting hardware assembly (E) 2. Insert the faucet body (1) into the hole on the deck w (4) and base o-ring (5), and then install the rubber w metal washer (7), mounting nut (8) and mounting sc underneath the sink.
- Page 9 Step 4 Step 5 Step 4 Step 5 Cold Water Water Step 4 Step 4 Step 6 Step 5 Step 5 4. Connect the spray 4. Connect the spray with a wrench unt Connect spray hose (H) to check valve (J) and tighten with an adjustable wrench.
- Page 10 Usage How to Operate the Handle spray h spray h ch until snug ˚ 1. Pull the lever to the right to ch until snug Close ˚ onnect h turn on the water. Push to the Close left to turn off spray h onnect h with a wrench, then turn on water supplies and check...
-
Page 11: Replacement Parts
Replacement Parts 1. Aerator Assembly 2. Hose 3. Aerator Head 4. Set Screw 5. Cap 6. Set Screw 7. Cap 8. Handle 9. Cartridge Cover 10. Locking Nut 11. Cartridge 12. Base 13. Base O-Ring 14. Rubber & Metal Washer 15. -
Page 12: Troubleshooting
Trouble - Shooting If you have followed the instructions carefully and your faucet still does not work properly, take the following corrective steps: P R O B L E M C A U S E A C T I O N Leakage under handle Locking nut (10) has Remove cap (7) at... - Page 13 Kraus USA, Inc. 12 Harbor Park Drive Port Washington, NY 11050 Toll-free 800-775-0703 Customerservice@kraususa.com If you are a plumbing contractor or trade professional please contact a Kraus Pro Representative at: Kraus USA, Inc. 12 Harbor Park Drive Port Washington, NY 11050 516-801-8955 Proservice@kraususa.com...
-
Page 14: Care And Maintenance
Do not use cloth with a coarse surface Push Unscrew the aerator and clean when necessary Left Open Hot Water *This installation manual is subject to change without further notice. Download the Kraus Care & Maintenance Guide at: http://www.kraususa.com/maintenance www.kraususa.com...
Need help?
Do you have a question about the KPF-1622 and is the answer not in the manual?
Questions and answers