Table of Contents
Advertisement
RECHARGE ECOJUMP:
Solid YELLOW Light - Your
EcoJump battery level is
too low to use the jump
start function. You must
recharge before attempting
to use as a jump starter.
NOTE: The EcoJump
can connect to your
smartphone using BLE
(Bluetooth Low Energy)
to inform you when your
battery is running low.
About EcoJump
The EcoJump is a portable & waterproof lithium jump
starter for vehicles with 12V lead-acid batteries (cars, trucks,
boats, ATVs, motorcycles, etc.). It is designed for easy & safe
use, with built-in reverse polarity & short circuit protection.
The EcoJump has clearly labeled & easy to understand
buttons, indicator lights, and connection ports. The EcoJump
also provides live updates to your phone, via Bluetooth
Low Energy, on the charge & temperature status of your
EcoJump, ensuring the unit is ready for use when needed
most! The EcoJump can be used up to 20 times on a single
charge to jump start most 12V battery vehicles. It also has
the convenience of two 5V USB ports for charging your
smartphone and other devices, a 200 Lumen flashlight, and
an emergency warning light.
NOTE: The EcoJump comes partially charged out of the box
but needs to be fully charged prior to use.
08
Extreme Temperature Mode:
DISCONNECT! Solid RED AND
RECHARGE ECOJUMP Solid
YELLOW - Refer to Extreme
Temperature Mode for details.
Battery Level Indicator
Each BLUE LED bar represents
20% of a charge. Five full LEDs
indicate a full charge. When
the EcoJump battery level is
below 15%, the first LED bar
will flash slowly.
Jump Starting Your Vehicle
CAUTION: Do
NOT attempt
to jump start if
unit and/or
connections are
wet or damp.
To access the jump start
connection on the side of
your EcoJump, pull tab on
the rubber cap that reads,
"ENGINE START." Once the
rubber cap is removed, the
jump start connection will
be exposed.
Carefully read and understand
the vehicle owner's manual
on specific precautions and
recommended methods for
jump starting the vehicle.
Make sure to determine the
voltage and chemistry of the
battery by referring to your
battery owner's manual prior
to using this product. The
EcoJump is for jump starting
standard vehicle 12V
lead-acid batteries only.
Connecting to
the Battery
Prior to connecting to your
battery, verify that it is a
12V lead-acid battery. The
EcoJump is not suitable for
PUSH TO SEAL
any other type of battery.
Identify the correct polarity
of the battery terminals on
the battery. The positive and
negative battery terminals
are typically marked by the
following letters or symbols,
respectively: (POS, P, +),
(NEG, N, -). Do NOT make
any connections to the
carburetor, fuel lines, or thin,
sheet metal parts. The
instructions below are for a
negative ground system.
If your vehicle is a positive
ground system (very
uncommon), follow Steps 1
and 2 in reverse order.
1
Connect the positive,
RED, clamp to the
positive (POS, P, +)
battery terminal.
2
Connect the negative,
BLACK, clamp to the
negative (NEG, N, -)
battery terminal or
vehicle chassis.
09
Advertisement
Table of Contents
