LG ProBeam HF80JS Owner's Manual page 10

•
To turn off the main power, remove the power plug, which should be positioned
so it is easy to access for operation.
•
Do not place anything containing liquid on top of the projector such as a vase,
flower pot, cup, cosmetics, or medicine; or ornaments, candles, etc.
• Never open any cover on the projector.
- There is a high risk of electric shock.
• Do not look directly into the lens when the projector is in use.
- The bright light may damage your eyes.
•
When the lamp is on or has just been turned off, avoid touching the air vent or
lamp, because these will be very hot.
•
Proper ventilation required, do not block airflow around unit. Doing so can
cause injury and internal overheating.
•
To prevent damage to lamp, unit must remain plugged in for approximately 3
minutes after power down to allow for proper cool down (not applicable on
LED models).
• Do not touch the lens; doing so can result in burns or damage to lens. Lens and
unit may be HOT during and immediately after use. Use caution when handling
unit, allowing for proper cool down.
•
Do not insert anything into or cover up the exhaust vents.
- This may result in fire or electric shock.
•
Do not insert pieces of metal such as coins, hairpins, or metal debris, nor
flammable materials such as paper or matches into the projector.
• Follow all maintenance guidelines for optimal use; service only at an authorized
service centre.
•
DISCONNECTING THE DEVICE FROM THE MAIN POWER
- The Power plug is the disconnecting device. In case of an emergency, the
Power Plug must remain readily accessible.
10