Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for 909 PLD5020A
Summary of Contents for 909 PLD5020A
- Page 1 INSTRUCTION MANUAL PLD5020A PL D5020A 100W Pain t Sprayer...
-
Page 2: Specifications
Specifications General safety rules General safety instructions for handling power tools. Voltage: 230 - 240 Vac WARNING: Read all safety warnings and all instructions. Failure Rated Power: 100W to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Reservoir Capacity: 700 ml This unit may not be used by people (including children) with... -
Page 3: Additional Safety Instructions For Spray Guns
• To reduce the risk of electric shock, the manufacturer instructions to operate the power tool. Power tools are recommends the use of a residual current of 30mA or less at dangerous in the hands of untrained users. all times. •... -
Page 4: Know Your Product
Know your product Assembly 7. Paint Pot 8. Paint Pot lid (additional pot only) 1. On/Off switch The PLD5020A Paint Sprayer does not require any 9. Flexible nozzle 2. Paint volume control dial pre-assembly before use. 10. Viscosity Cup 3. Air vent What substances can this Paint Sprayer be used with? 11. -
Page 5: Preparing For Operation
Measuring the Viscosity To measure the viscosity of the spray material follow these instructions (refer Fig 1): 1. Dip the viscosity test cup completely into the spray material to be used. 2. Hold the test cup up and Fig. 3 Fig. -
Page 6: Cleaning And Maintenance
Replacing the Spring Valve assembly 2. To decrease the paint flow, turn the Paint Volume Control dial to the right. (refer Fig 5). An additional Spring Valve assembly (5) has been supplied with this product. Using the Flexible Nozzle Note: Ensure the product is NOT connected to the mains power NOTE: Ensure the product is NOT connected to the mains power before changing the spring valve assembly on the sprayer. -
Page 7: Troubleshooting
5. Grasping the nozzle, firmly pull the valve/pump assembly out of the spray gun. 6. Thoroughly clean all soiled parts, especially clean the intake and runback holes with the provided nozzle cleaner pin. 7. Reassemble the parts in reverse order. Attention! Place the intake holes on the pump downwards when reassembling the valve/pump assembly (13).
Need help?
Do you have a question about the PLD5020A and is the answer not in the manual?
Questions and answers