Antenna Connections; Cable Tv Connections - Hitachi 32E10 Owner's Manual

Led lcd hdtv
Table of Contents

Advertisement

Antenna connections

If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your antenna system. If you
are using a Cable TV service, see Cable TV connections.
Combination VHF/UHF Antenna (Single 75 ohm cable)
Antenna
Jack
75 ohm
Coaxial
Cable

Cable TV connections

This TV has an extended tuning range and can tune most cable channels without using a Cable TV Converter box. Some
cable companies offer "premium pay channels" where the signal is scrambled. Descrambling these signals for normal
viewing requires the use of a descrambler device which is generally provided by the Cable TV company.
For subscribers to basic Cable TV service
75 ohm
Coaxial Cable
For subscribers to scrambled Cable TV service
If you subscribe to a Cable TV service which requires the use of a Converter/Descrambler box, connect the incoming 75 ohm Coaxial
Cable to the Converter/Descrambler box. Using another 75 ohm Coaxial Cable, connect the output jack of the Converter/Descrambler
box to the Antenna Jack on the TV. Follow the connections shown below. Set the TV to the output channel of the Converter/Descrambler
box (usually channel 3 or 4) and use the Converter/Descrambler box to select channels.
Incoming 75 ohm Cable TV Cable
For subscribers to unscrambled Cable TV service with scrambled premium channels
If you subscribe to a Cable TV service in which basic channels are unscrambled and premium channels require the use of a Converter/
Descrambler box, you may wish to use a signal Splitter and an A/B Switch box (available from the Cable TV company or an electronics
supply store). Follow the connections shown below. With the switch in the "B" position, you can directly tune any non-scrambled channels
on your TV. With the switch in the "A" position, tune your TV to the output of the Converter/Descrambler box (usually channel 3 or 4) and
use the Converter/Descrambler box to tune scrambled channels.
Incoming
75 ohm
Cable TV
Cable
Connect the 75 ohm cable from the combination VHF/UHF antenna to the Antenna
Jack.
For basic Cable TV service not requiring a Converter/Descrambler box, connect the
75 ohm Coaxial Cable directly to the Antenna Jack on the back of the TV.
Antenna
Jack
Converter/
Descrambler
Converter/
Descrambler
Splitter
75 ohm Cable to TV
75 ohm Cable to TV
A
A/B Switch
B
Antenna
Antenna
Jack
Jack
75 ohm
Coaxial Cable
Antenna
Antenna
Jack
Jack
75 ohm
Coaxial Cable
13 EN

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

22e3049e3049e30149e30a

Table of Contents