Advertisement
HOW TO USE
• Select the brush head to suit your skin type and cleansing need. Gently push the brush head
onto the cleansing brush handle.
• Moisten the brush bristles by running under water.
NOTE: DO NOT use the cleaning brush whilst completely dry as this can cause skin irritation.
• Dampen your skin with water and apply cleanser onto your skin. Alternatively, apply your
cleanser directly onto the brush.
• Place the cleansing brush directly onto your skin.
• Switch on using the On/Off button.
• Select the speed:
The cleansing brush will automatically start on speed 1
Press the button again for speed 2
Press the button again twice for speed 3
TIP: When changing the brush heads, test each head on different speeds to identify which is
most comfortable for you. Gently glide the brush over the skin in circular motions avoiding the
delicate eye area. When you feel a pause, move onto the next area.
NOTE: The facial brush will run on a one minute timer, after one minute the device will turn off
indicating that you have completed your recommended daily cleansing. To continue to use the
cleansing brush for longer than one minute simply press the On/Off button again to enter a new
one minute cycle.
• If you wish to end the cleansing cycle early press the On/ Off button as per below:
When using speed 1, press On/Off button 3 times
When using speed 2, press On/Off button twice
When using speed 3, press On/Off button once
• When not in use, store the brush attachments with the protective caps on.
• Ensure the bristles are dry before attaching the protective cap.
TIP: For storage without fraying the brush bristles turn the handpiece on to speed 1 and slowly
lower the protective cap onto the head until all brush bristles are neatly inside the protective
cap, then switch off the unit.
NOTE: Try to avoid applying too much pressure with the brush when directly on the skin. If this
happens the brush will automatically stop its cycle and switch off. This is perfectly normal and
helps to ensure a comfortable treatment. The cleansing brush can be restarted by pressing the
ON switch.
9
Advertisement
