Important Safety Instructions - Magnavox 43MV347X Owner's Manual

Table of Contents

Advertisement

Important safety instructions

1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in
accordance with the manufacturer's instructions.
8. Do not install near any heat sources such as
radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or
grounding type plug. A polarized plug has two
blades with one wider than the other. A grounding
type plug has two blades and a third grounding
prong. The wide blade or the third prong are
provided for your safety. If the provided plug does
not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protect the power cord from being walked on or
pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
11. Only use attachments / accessories specified by
the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or
table specified by the manufacturer,
or sold with the apparatus. When a
cart is used, use caution when
moving the cart / apparatus
combination to avoid injury from
tip-over.
Wall mount bracket kit
Brand
43MV347X
SANUS
Your TV meets the VESA standard for wall mounting.
Consult with your local dealer for a wall mount bracket
which is compatible with your TV model.
The recommended wall mount bracket kit (sold separately)
allows the mounting of the TV on the wall.
For detailed information on installing the wall mount, refer
to the wall mount Instruction book.
Funai is not responsible for any damage to the product or
injury to yourself or others if you elect to install the TV wall
mount bracket or mount the TV onto the bracket on your
own.
The wall mount bracket must be installed by experts.
Model #
Screw dimension
M4 x 1.378"
25BB
(35mm)
13. Unplug this apparatus during lightning storms or
when unused for long periods of time.
14. Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has
been damaged in any way, such as power-supply
cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
Note to the CATV system installer:
This reminder is provided to call the CATV system installer's
attention to Article 820-40 of the NEC that provides guidelines
for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
Example of antenna grounding as per NEC - National
Electric Code
GROUND CLAMP
ELECTRIC SERVICE EQUIPMENT
Funai is not liable for these types of accidents or
injuries noted below.
Install the wall mount bracket on a sturdy vertical wall.
If installed onto a ceiling or slanted wall, the TV and wall
mount bracket may fall which could result in a severe
injury.
Do not use screws that are longer or shorter than their
specified length. If screws too long are used this may
cause mechanical or electrical damage inside the TV set.
If screws too short are used this may cause the TV set to
fall.
Do not fasten the screws by excessive force. This may
damage the product or cause the product to fall, leading
to an injury.
For safety reasons use 2 people to mount the TV onto a
wall mounting bracket.
Do not mount the TV onto the wall mounting bracket while
your TV is plugged in or turned on. It may result in an
electrical shock injury.
When installing the unit on the wall, allow this
much space.
: 11.8 inches (30cm)
Top
: 5.9 inches (15cm)
Left and right side
: 3.9 inches (10cm)
Bottom
3
ANTENNA LEAD IN WIRE
ANTENNA DISCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING ELECTRODE
SYSTEM (NEC ART 250, PART H)

Advertisement

Table of Contents
loading

Table of Contents