Fujitsu lifebook C1320 User Manual page 38

Problem
Parallel, Serial, and USB Device Problems
You have installed
a parallel port
device, a serial
port device or a
USB device.
Your LifeBook
notebook does not
recognize the
device or the
device does not
seem to work
properly.
Downloaded from www.Manualslib.com
Possible Cause
The device is not
properly installed.
The device may have
been installed while an
application was running,
so your notebook is not
aware of its installation.
Your device may not have
the correct software driver
active.
You may have the wrong I/
O address selected for
your device.
Your device and another
device are assigned the
same I/O address.
Parallel port is set to
output only.
manuals search engine
Tr o u b l e s h o o t i n g
Possible Solution
Remove and re-install the device.
Close the application and restart your
notebook.
See your software documentation and activate
the correct driver.
See your device documentation and software
documentation to determine the required I/O
address.
Change the settings in the BIOS setup utility.
Check all I/O addresses located within the
BIOS setup utility and any other installed
hardware or software to make sure there are
no duplications.
Check parallel port setting in the BIOS and set
to bi-directional or ECP.
27