1. Manuals
  2. Brands
  3. skeye. Manuals
  4. Drones
  5. NANO DRONE
  6. User manual

skeye. NANO DRONE User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

SKEYE
Nano Drone
USER GUIDE
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NANO DRONE and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for skeye. NANO DRONE

  • Page 1 SKEYE Nano Drone USER GUIDE...

  • Page 2: Identification Des Pièces

    Identification des pièces SKEYE Nano Drone Remplacer les pales du rotor Controller USB Charging Cable Controller Functions Forward/Backward Trimmer Throttle / Direction Forward/ Rotate Backward Sideways Sideways Left/Right Trimmer Power Switch (ON/OFF)

  • Page 3: Getting Started

    Getting Started Battery Installation Open the controller Install 2x 1.5V AAA Lock the battery cover. battery cover. batteries into the controller. Charging Connect the USB charging cable to a USB port. The LED on the USB charging cable lights red indicating that the battery is charging. When the battery is fully charged, the LED on the USB charging cable turns off.

  • Page 4: Flying Your Drone

    Throttle Control To start or to fly higher, push the throttle/rotate stick cautiously forwards. To land or fly lower, push the throttle/rotate stick cautiously backwards. Direction Control To fly the drone forwards or backwards, push the direction stick cautiously to forwards or backwards.

  • Page 5: Sensitivity Control

    Slide the power switch to the ON position. The controller will emit a tone to indicate that binding is complete. At the same time, two LED lights on the drone will start to flash slowly. The controller needs to be calibrated after successful binding: move the throttle/ rotate stick to the full up position and then push the throttle/rotate stick to the full down position.
  • Page 6 Left Side 360° Flip Press the direction stick and push it to the left once you’ve heard the tone. Right Side 360° Flip Press the direction stick and push it to the right once you’ve heard the tone. Forward 360° Flip Press the direction stickand push it forward once you’ve heard the tone.
  • Page 7 Do not attempt these stunts until you are able to fly confidently. Choose an area that will provide a soft landing (carpet or grass) and maintain an altitude of at least 10 feet/3 meter to allow room to recover control as you WARNING practice flipping the model.

  • Page 8: Replacing Rotor Blades

    Calibration The drone needs to be calibrated if it flies unstable. Place the drone on a flat surface and calibrate throttle (See 4 under “Flying Your Drone”) Set the sensitivity to high. Keep the throttle in the minimum position. Move the direction stick to the upper left corner, the throttle/rotate stick into the lower left corner.

  • Page 9: Troubleshooting

    Troubleshooting Problem: Controller does Your Drone”. Problem: The drone does not work. Cause: The power switch is not lift. Cause: The rotor blades turned “OFF”. rotate too slowly. Solution: Turn the power switch “ON”. Solution: Push the Cause: The batteries have throttle up.

  • Page 10: Safety Precautions

    Safety Precautions • Carefully follow the directions and warnings for this drone and any optional support equipment you may use. • Never operate your drone with low controller batteries. • The drone has rotating blades that move at high speed, posing danger of damage and injury.
  • Page 11 Caring For Your Drone • For best performance, only use fresh Alkaline “AAA” batteries in the controller. • After each crash, inspect your drone for worn or damaged parts. • The drone automatically switches off if the rotors are unable to rotate. Switch the power to restart the drone.

Table of Contents